Hydra Slimdesk User manual

1 | P a g e
Hydra
Instruction Manual
Slimdesk
All manuals and user guides at all-guides.com

2 | P a g e
1) Fasten the legs in place
All manuals and user guides at all-guides.com

3 | P a g e
2) Place the corner-lock pieces into each
corner of the desk.
All manuals and user guides at all-guides.com

4 | P a g e
3) Position the leg support panel
4) Position the PSU on the support in the
leg
All manuals and user guides at all-guides.com

5 | P a g e
5) We strongly recommend you take the
faux-bottom off and pass all the necessary
wires before proceeding
Screw locations below
All manuals and user guides at all-guides.com

6 | P a g e
6) We recommend you position the USB and
power button wires along the rad. supports
(step 5) –we recommend passing them in the
small opening under the rad. support
All manuals and user guides at all-guides.com

7 | P a g e
7) Position the 5.25” bays (the lock
underneath the faux-bottom), GPU brackets
and radiator mounts (now is also a good time
to place the radiators)
All manuals and user guides at all-guides.com

8 | P a g e
8) Assemble the 5.25” bay brackets and
position them (screws are below); place the
GPU “columns”
All manuals and user guides at all-guides.com

9 | P a g e
9) Position the SSD/HHDs by fastening the
lower one to the desk and rest on top with
the provided brackets
All manuals and user guides at all-guides.com

10 | P a g e
10) You may now place the side panels (6
screws per panel) and the glass to close
your desk
All manuals and user guides at all-guides.com

11 | P a g e
GPU Installation
GPUs are installed in a “misaligned”
configuration and the back on the GPU rests
on the support rods provided (shorter for
lower GPU, longer for the higher one.
For SLI configuration we provide a flexible
bridge.
All manuals and user guides at all-guides.com

12 | P a g e
All manuals and user guides at all-guides.com