Hydra Slimdesk User manual

1 | P a g e
Hydra
Instruction Manual
Slimdesk

2 | P a g e
1) Fasten the legs in place

3 | P a g e
2) Place the corner-lock pieces into each
corner of the desk.

4 | P a g e
3) Position the leg support panel
4) Position the PSU on the support in the
leg

5 | P a g e
5) We strongly recommend you take the
faux-bottom off and pass all the necessary
wires before proceeding
Screw locations below

6 | P a g e
6) We recommend you position the USB and
power button wires along the rad. supports
(step 5) –we recommend passing them in the
small opening under the rad. support

7 | P a g e
7) Position the 5.25” bays (the lock
underneath the faux-bottom), GPU brackets
and radiator mounts (now is also a good time
to place the radiators)

8 | P a g e
8) Assemble the 5.25” bay brackets and
position them (screws are below); place the
GPU “columns”

9 | P a g e
9) Position the SSD/HHDs by fastening the
lower one to the desk and rest on top with
the provided brackets

10 | P a g e
10) You may now place the side panels (6
screws per panel) and the glass to close
your desk

11 | P a g e
GPU Installation
GPUs are installed in a “misaligned”
configuration and the back on the GPU rests
on the support rods provided (shorter for
lower GPU, longer for the higher one.
For SLI configuration we provide a flexible
bridge.

12 | P a g e