CAUTION: Read and follow all instructions
before operating fan. Do not use fan if any
part is damaged or missing. Do not alter the
fan’s assembly.
WARNING
To reduce the risk of fire or electrical
shock:
• Do not expose to water or rain.
• Do not use this fan with any solid
state speed control device.
To reduce the risk of injury or damage:
• If the fan is automatically operated,
disconnect from power supply
before servicing.
• If the power supply cord is
damaged, contact your local
service center or a qualified
electrician to install an appropriate
replacement cord.
Do not operate this fan in locations
where special conditions prevail, such as
the presence of a corrosive or explosive
atmosphere (dust, vapor, or gas).
This fan is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge.
RULES FOR SAFE OPERATION
1. Never insert fingers or any other objects
through the grill guard when fan is
operating.
2. Disconnect the fan from its power source
when moving from one location to
another, or when removing guards for
cleaning.
3. Be sure fan is on a stable, flat surface when
in operation.
4. Do not use fan in windows. Rain and
moisture may create electrical hazard.
5. Close supervision is necessary when fan is
used near children, the elderly and pets.
6. Do not place the fan near an open flame,
cooking or heating appliance, or hot
surface.
7. This fan should not be operated outside.
INSTRUCTIONS
WARNING: Be sure that both front
and rear guard screws are completely
tightened in locking position before
operation.
OPERATING INSTRUCTIONS
To adjust airflow upward or downward
Tilt fan head to the desired angle.
This high velocity fan can be used alone
or in conjunction with air conditioning.
Rotating the fan head upward serves
to pull air from the floor and circulate it
throughout the entire room.
Speed control
Select air speed by setting switch to
either HIGH(3), MIDDLE(2), LOW(1), or
OFF(0).
It is normal for the motor to feel warm to
touch after continuous operation.
The fan thermostat will automatically
shut off power if the fan overheats. If this
happens, immediately unplug the fan
from the outlet.
CLEANING INSTRUCTIONS
WARNING: Unplug from electrical
supply source before cleaning.
1. Use soft damp cloth to clean, then wipe
with dry cloth.
2. Do not use a cleaning solution that is
harmful to paints or plastics.
3. Do not bend the blades.
3
