-
1
-
CHC-400 is newest generation capacitive torch height controller improved
based on old models “CHC-200E&CHC-200D”. It shares the same connection
ports with CHC-200E&CHC-200D, and with new features as below:
Power supply: AC20~24V or DC 20~36V.
Automatic detecting function: automatically detect the balance position, collision
and disconnection status etc.
HF cables can be used from 800mm to 1800mm, if change the HF cables, will
automatically do the detection and adjustion work.
Improve the collision and disconnection protection function.
SAFETY：
Please read this manual fully before use CHC-400
DO NOT open cabinet of THC unless trained technician.
DO NOT adjust the sealed resister.
Turn off Power supply if when THC is unused.
DO NOT put liquid on THC.
Attention Anti-dust work, DO NOT let metal dust into THC.
DO NOT use on plasma over 100A or HF plasma
Installation Note：
GND Port must be well grounded, GND resister≤1Ω.
UP/DOWN on THC must be same to Z-axis Lifter
To Customer：
We only supply to re-seller as CNC cutting machine manufacturer, engineering company…
end-user please contact our local distributor for product supplying.
We offer technical support to all distributors and users of our product.
The product is under ONE year warranty since delivery, and enjoys life-long service and
support.
IMPORTANT NOTE：
All our THCs have been tested in our workshop before delivery, all commissioning work has
been done. Please NOT change the setting without informing your supplier.
