i-Life V3s User manual

For more detailed information, please visit: www.iliferobot.com
Contact Us
Email Us
Technical Support
[email protected]
Tweet Us
@ILIFEROBOTICS
Mon-Fri: 9:00am - 18:00pm
Sat: 9:00am - 12:00am (GMT+8)
For more detailed information, please visit: www.iliferobot.com
ILIFE Customer Service
Toll-Free Number:
1-800-631-9676 (USA and Canada)
[phone] (Outside USA and Canada)

Note: If all above solutions don’twork, please take below actions.
1. Re-set the robotby re-turning on the power switch.
2. If re-set action doesn’twork, please contact [e-mail]
Wheels or sidebrushes
disfunction
Check wheels or side
brushes
sensor failure bumper slightly, check whether
there isforeign matter
Main body gets stuck Move main body and start
again
Short tone
NO. Tone Cause Solution
01
02
03
Positioning the charging dock.
Wake up and charge your robot
Please the charging dock against a wall and connect the
adapter to an outlet. Itis suggested to leave an area with
at least 4 feet (1 meter) on each sideof the charging dock,
and at least 8 feet ( 2 meters) in front of the charging dock.
Do notplace the charging dock around doors and stairs.
For optimizing performance of your robot, try best to place the charging dock in an
open and uncluttered area.
Always keep the power switch turned on during your
don't use your robot for more than oneweek.
Switch on the robot
Pause
A. Make sure the power switch is on.
B. Press CLEAN on the robotoron the remote control to start cleaning.
Pause the robot to switch from cleaning mode to select mode.
A. Press CLEAN button on the robot.
B. Press button on the remote control.
* To switch from sleep mode to select mode, press CLEAN. Press CLEAN again to
start cleaning.
Turn on the power switch at the sideof body, then place
your roboton the charging dock for a full charge.
Before You Get Started See How V3s Pro Works
1.
2.
V3s Pro is ready to clean
Robot Maintenance
Trouble Shooting
1
2
Scheduling
Sleep
To turn robotinto sleeping modefrom selected mode:
Setting local time
A. Point the remote control towards the robot.
(Make sure the power switch is on.)
B. Press and then use directional buttons to set the correct time.
C. Press to save the setting.
A. Keep pressing CLEAN button on main body for3 seconds.
B. Robot enters sleep modeif itdoes not receive any commandsin 15 seconds.
3
Error code sheet
When the robot meets with some routine troubles ,it will remind you by beep.
Setting a schedule
A. Point the remote control towards the robot.
B. Press and then use directional buttons to set the scheduled.
C. Press to save the setting. To cancel the schedule, please set the time
after each use (High Performance Filter can’tbewashed with water).
Replace with anew one when itisneeded.