I-novative 1000BASE-T1 User manual

Flash Manual
Auto-Link-SPE-G
1000BASE-T1 Media Converter
INO_Auto-Link-SPE-G_Flash_Manual_V1.0.docx

INO_Auto-Link-SPE-G_Flash_Manual_V1.0.docx
Rev. 1.0
2021-04-25
2 / 3
Table of Contents
Revision History................................................................................................................................2
1Firmware Update.......................................................................................................................3
1.1 Introduction.........................................................................................................................3
1.2 Preparation.........................................................................................................................3
1.3 Installation..........................................................................................................................3
2Support Information...................................................................................................................3
Revision History
Revision
Date
Change
1.0
04/25/2021
initial version

INO_Auto-Link-SPE-G_Flash_Manual_V1.0.docx
Rev. 1.0
2021-04-25
3 / 3
1 Firmware Update
1.1 Introduction
The firmware of theAuto-Link-SPE products can be upgraded using the AVRDUDE open source
tool running on a Linux machine. Linux can either run on a physical PC or in a virtual machine like
VirtualBox. The only prerequisite is that is has access to the Auto-Link-SPE via USB. We
recommend using Ubuntu 20.04 LTS, but any other distribution being able to run AVRDUDE will
work too.
1.2 Preparation
Install AVRDUDE if it is not yet installed.
# sudo apt install avrdude
Attach the Auto-Link-SPE via USB to your Linux machine.
Make sure that only one Auto-Link-SPE is attached.
Check whether theAuto-Link-SPE device is seen by the operating system.
# lsusb -d 0403:7f85
Bus 001 Device 003: ID 0403:7f85 Future Technology Devices International, Ltd
1.3 Installation
Unpack the firmware archive and change into the firmware folder.
# cd <your home directory>
# tar xf auto-link-spe-g-<version>.tgz
# cd auto-link-spe-g
Run the flash script
# sudo ./flash-auto-link.sh
2 Support Information
If you have questions concerning our product, please contact us:
Manufacturer:
E-Mail:
[email protected]
i-novative® GmbH
Phone:
[phone]
Kesselbodenstrasse 11
Fax:
[phone]
85391 Allershausen
Internet:
www.i-novative.de