IBASE Technology SI-624-AI User manual

1
SI-624-AI
Extreme Performance
Digital Signage Player
User’s Manual
Version 1.0
(December 2023)

Copyright
©2023 IBASE Technology, Inc. All rights reserved.
No part of this publication may be reproduced, copied, stored in a retrieval system, translated
into any language or transmitted in any form or by any means, electronic, mechanical,
photocopying, or otherwise, without the prior written consent of IBASE Technology, Inc.
(hereinafter referred to as “IBASE”).
Disclaimer
IBASE reserves the right to make changes and improvements to the products described in
this document without prior notice. Every effort has been made to ensure the information in
the document is correct; however, IBASE does not guarantee this document is error-free.
IBASE assumes no liability for incidental or consequential damages arising from
misapplication or inability to use the product or the information contained herein, nor for any
infringements of rights of third parties, which may result from its use.
Trademarks
All the trademarks, registrations and brands mentioned herein are used for identification
purposes only and may be trademarks and/or registered trademarks of their respective
owners.

3
Compliance
In a domestic environment, this product may cause radio interference in which case
users may be required to take adequate measures.
This product has been tested and found to comply with the limits for a Class B
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with manufacturer’s instructions, may cause
harmful interference to radio communications.
WEEE
This product must not be disposed of as normal household waste, in
accordance with the EU directive of for waste electrical and electronic
equipment (WEEE - 2012/19/EU). Instead, it should be disposed of by
returning it to a municipal recycling collection point. Check local
regulations for disposal of electronic products.
Green IBASE
This product is compliant with the current RoHS restrictions and
prohibits use of the following substances in concentrations exceeding
0.1% by weight (1000 ppm) except for cadmium, limited to 0.01% by
weight (100 ppm).
•Lead (Pb)
•Mercury (Hg)
•Cadmium (Cd)
•Hexavalent chromium (Cr6+)
•Polybrominated biphenyls (PBB)
•Polybrominated diphenyl ether (PBDE)

Important Safety Information
Carefully read the precautions before using the device.
Environmental conditions:
•Lay the device horizontally on a stable and solid surface in case the device may
fall, causing serious damage.
•Leave plenty of space around the device and do not block the openings for
ventilation. NEVER DROP OR INSERT ANY OBJECTS OF ANY KIND INTO
THE VENTIILATION OPENINGS.
•Use this product in environments with ambient temperatures between 0˚C and
45˚C.
•DO NOT LEAVE THIS DEVICE IN AN ENVIRONMENT WHERE THE
STORAGE TEMPERATURE MAY IS BELOW -20°C OR ABOVE 80°C. This
could damage the device. The device must be used in a controlled environment.
Care for your IBASE products:
•Before cleaning the device, turn it off and unplug all cables such as power in case
a small amount of electrical current may still flow.
•Use neutral cleaning agents or diluted alcohol to clean the device chassis with a
cloth. Then wipe the chassis with a dry cloth.
•Vacuum the dust with a computer vacuum cleaner to prevent the air vent or slots
from being clogged.
WARNING
Attention during use:
•Do not use this product near water.
•Do not spill water or any other liquids on your device.
•Do not place heavy objects on the top of the device.
•Operate this device from the type of power indicated on the marking label. If you
are not sure of the type of power available, consult your distributor or local
power company.
•Do not walk on the power cord or allow anything to rest on it.
•If you use an extension cord, make sure that the total ampere rating of the
product plugged into the extension cord does not exceed its limits.
Avoid Disassembly
Do not disassemble, repair or make any modification to the device. Doing so could
generate hazards and cause damage to the device, even bodily injury or property
damage, and will void any warranty.

5
CAUTION
There is danger of explosion if internal lithium-ion battery is replaced by an incorrect
type. Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer’s instructions.
Warranty Policy
•IBASE standard products:
24-month (2-year) warranty from the date of shipment. If the date of shipment
cannot be ascertained, the product serial numbers can be used to determine
the approximate shipping date.
•3rd-party parts:
12-month (1-year) warranty from delivery for the 3rd-party parts that are not
manufactured by IBASE, such as CPU, CPU cooler, memory, storage devices,
power adapter, panel and touchscreen.
＊PRODUCTS, HOWEVER, THAT FAIL DUE TO MISUSE, ACCIDENT,
IMPROPER INSTALLATION OR UNAUTHORIZED REPAIR SHALL BE
TREATED AS OUT OF WARRANTY AND CUSTOMERS SHALL BE BILLED
FOR REPAIR AND SHIPPING CHARGES.
Technical Support & Services
1. Visit the IBASE website at www.ibase.com.tw to find the latest information about
the product.
2. If you need any further assistance from your distributor or sales representative,
prepare the following information of your product and elaborate upon the
problem.
•Product model name
•Product serial number
•Detailed description of the problem
•The error messages in text or in screenshots if there is any
•The arrangement of the peripherals
•Software in use (such as OS and application software, including the version
numbers)
3. If repair service is required, you can download the RMA form at
http://www.ibase.com.tw/english/Supports/RMAService/. Fill out the form and
contact your distributor or sales representative.

Table of Contents
Chapter 1 General Information...............................................................8
1.1 Introduction.............................................................................................9
1.2 Features..................................................................................................9
1.3 Packing List ..........................................................................................10
1.4 Specifications........................................................................................10
1.5 Product View.........................................................................................12
1.6 Dimensions...........................................................................................14
Chapter 2 Hardware Installation & Motherboard Information ............15
2.1 Installation / Replacement.....................................................................16
2.1.1 Memory ..................................................................................17
2.1.2 M.2 Cards...............................................................................17
2.1.3 WiFi / 3G / 4G Antenna Installation.........................................19
2.1.4 Mounting Installation...............................................................20
2.2 Setting the Jumpers..............................................................................21
2.3 Jumper & Connector Locations on Motherboard...................................22
2.4 Jumper Locations..................................................................................23
2.4.1 JP1: Clear CMOS Data...........................................................23
2.4.2 JP2: Clear RTC ......................................................................23
2.4.3 JP3: AT/ATX Select................................................................24
2.4.4 JP5: Flash Descriptor Security Override.................................24
2.4.5 JP6: Sierra EM9191 5G Card USB/PCIe Select .....................25
2.5 Connectors Locations ...........................................................................26
2.5.1 Front Side Connectors............................................................26
2.5.2 Rear Side Connectors ............................................................26
2.5.3 CN8: DC In Connector............................................................27
2.5.4 CN10, CN11: SATA Connectors.............................................27
2.5.5 J1: External Power Switch......................................................28
2.5.6 J2: Front Panel Audio Connector............................................28
2.5.7 J4: OOB..................................................................................29
2.5.8 J5: Digital I/O Connector (4 in, 4 out)......................................30
2.5.9 J7: M.2 2280 M-Key Socket (supports NVME)........................30
2.5.10 J8: Reset Button Connector....................................................31
2.5.11 J9, J11: COM3, COM4 RS232 Serial Ports ............................31
2.5.12 J13: USB 2.0 Connector.........................................................32
2.5.13 J14: USB 3.1 Connector.........................................................33

7
2.5.14 J15: M.2 2230 E-key Socket...................................................34
2.5.15 J17: M.2 3053 B-Key Socket ..................................................34
2.5.16 J18: Mini SIM Socket..............................................................35
2.5.17 J22: M.2 2280 M-Key Socket..................................................35
2.5.18 J23, J24: SATA HDD Power Connectors................................36
2.5.19 PWM Fan Power Connector (CPU_FAN1, SYS_FAN1,
SYS_FAN2) ...........................................................................................36
2.5.20 CN9: MXM Connector.............................................................37
Chapter 3 Driver Installation .................................................................39
3.1 Introduction...........................................................................................40
3.2 Intel®Chipset Software Installation Utility..............................................40
3.3 HD Audio Driver Installation..................................................................41
3.4 LAN Driver Installation ..........................................................................41
3.5 Intel®Management Engine Components Drivers Installation.................42
3.6 NVIDIA®GeForce®MXM Driver Installation ..........................................42
Chapter 4 BIOS Setup............................................................................43
4.1 Introduction...........................................................................................44
4.2 BIOS Setup...........................................................................................44
4.3 Main Settings........................................................................................45
4.4 Advanced Settings................................................................................46
4.5 Chipset Settings....................................................................................58
4.6 Security Settings...................................................................................60
4.7 Boot Settings.........................................................................................61
4.8 Save & Exit Settings..............................................................................62
Appendix ......................................................................................................63
A. I/O Port Address Map............................................................................64
B. Interrupt Request Lines (IRQ)...............................................................66
C. Watchdog Timer Configuration..............................................................67

Chapter 1
General Information
The information provided in this chapter includes:
•Features
•Packing List
•Accessories
•Specifications
•Product View
•Dimensions

General Information
SI-624-AI User Manual
9
1
1.1 Introduction
The SI-624-AI is a power-packed industrial AI computer with NVIDIA Ampere MXM
GPU that is designed to meet the demands of high-speed multiple tasks for artificial
neural network applications. Powered by the 12th/13th Gen Intel® Core™CPU, this
cutting-edge system delivers image processing capabilities that enable real-time
analysis of visual data, enhancing automation, quality control, and overall production
efficiency for AIoT applications in smart factory, retail, transportation or medical
fields. It is suitable for use as a digital signage control system in mission-critical
control rooms in transportation networks, smart retail, healthcare, or medical fields
where remote AI data analysis capabilities are required.
The compact SI-624-AI features four DP++ outputs for simultaneous high-resolution
displays in multi-monitor configurations and reliably delivers high-quality live video or
AI analytics content with 4x 4K or 2x 8k display outputs, enabling institutions to
connect and communicate with their audiences. It is equipped with iSMART
intelligent energy-saving and Observer remote monitoring technologies to reduce
energy consumption and minimize downtime.
1.2 Features
•iSMART intelligent energy-saving & Observer remote monitoring
technologies
•12th/13th Gen Intel® Desktop Core™i7/i5/i3 / Pentium® / Celeron® QC/DC
processors
•4x DDR4-3200 UDIMM, Max.128GB
•NVIDIA Ampere Architecture MXM GPU cards (Type A/B, up to 115W)
•4x DP++ output
•1x M.2 B-Key (3052) for 5G or LTE options
•1x M.2 E-Key (2230) & 2x M.2 M-Key (2280) for Wi-Fi, Bluetooth, capture or
storage options
•Supports OOB function via I210 LAN port (optional)
•Supports TPM 2.0

10
SI-624-AI User Manual
1.3 Packing List
Your product package should include the items listed below. If any of the
items below is missing, contact the distributor or the dealer from whom you
purchased the product.
•SI-624-AI
•Power Adaptor
•Power Cord
•Cable Bracket
1.4 Specifications
Model Name
SI-624-AI
Mainboard
MBD624
Operating
System
Windows 10 & Linux
CPU
12th/13th Gen Intel® RPL-PS Core™processors
CPU Socket
LGA1700
Chipset
Q670E/R680E PCH
Memory
4x DDR4-3200 SO DIMM, Max. 128GB
Graphics
12th/13th Gen Intel® Core™i9/i7/i5/i3 processors integrated
LAN
2x Gigabit LAN
Expansion
Slots
•1x M.2 E-Key (2230)
•1x M.2 B-Key (3052)
•1x M.2 (M-Key, type:2280, supports NVMe with PCI-E(x4)
Gen.4 signal only)
•1x M.2 (M-Key, type:2280 , supports PCIe Gen.3 & SATA)
•1x UIM/SIM card slot
•1x MXM 3.1 Type-B
I/O
Interface
•1x HDMI 1.4 for console
•4x DisplayPort
•4x USB 3.0
•2x RJ45 for Gigabit LAN
•COM1 & COM2: RS-232/422/485 (jumper-less selection)
•1x Audio connector for Line-in/out/MIC
•1x Power / HDD LED
•1x Power button
•1x Power jack connector