Idavee Presto Pure IAE15 User manual

16
Thank you for choosing the PrestoPureTM
Automatic Soy/Nut Milk, Soup and Juice
Machine! Don’t forget to check our website
idavee.com for recipes, support and more!
Idavee, LLC
Lincoln, Nebraska USA
800-656-7830
idavee.com
AUTOMATIC SOY/NUT MILK, SOUP, JUICE MACHINE
MODEL #IAE15
LINCOLN, NE USA
IDAVEE.COM
INSTRUCTION MANUAL

2
Please read the following instructions before using this appliance.
Please keep this booklet for reference. You can also find it on our
website at idavee.com
WARRANTY AND REPAIR SERVICE
This product is supplied with limited warranty for one year from
the date of purchase. Use of the product not in accordance with
the instructions will not be covered under warranty. You may
contact our toll free line for service or support at 1-800-656-7830
This product has been reviewed for quality assurance and meets
all safety standards in the United States. Idavee LLC assumes no
liability for personal injury or property damage due to misuse of
product or lack of maintenance. The warranty is null and void if
there are any alterations to this product or if it is used improperly
(such as, in a commercial setting). This product is intended for
home use only.
15
PROBLEM POSSIBLE CAUSE SOLUTION
Milk overflows
Overflow sensor has
not been washed
properly before use
Clean the overflow sensor
well before each use
Wrong buon has been
pressed
Use the correct funcon for
the ingredients used
Milk is too thick
Use the measuring cup
included in the box and
follow instrucons
The machine is defecve Open a support case -
support@idavee.com
Soymilk has burnt
taste
Machine has not been
cleaned well before use
Thoroughly clean the
machine before use. Using a
cleaning pad to clean the
Sweetener added before
the cycle starts
Never add sugar or honey
before the cycle completes.
You may add it aerwards
Milk is too thick
Use the measuring cup
included in the box and
follow instrucons
Use of dislled or
puried water causes Use tap water
Water temperature is too
low
Use room temperature
water
Soy milk has not
been properly
cooked
Excessive grains or water
Use the measuring cup
included in the box and
follow instrucons
Other issues
Send an email to:
support@idavee.com or call
800-656-7830
TROUBLESHOOTING, CONTINUED

14
PROBLEM POSSIBLE CAUSE SOLUTION
Button control panel
off / no operation
Outlet has no power
Ensure the switch is
turned on and connected
to the outlet
The power cord is not
properly connected to the
appliance or outlet
Properly connect cord to
the appliance and the plug
into the outlet
Control panel
buttons lit, but the
machine is not
working
No water or not enough
water in the barrel
Fill water levels between
MIN and MAX
Faulty control panel or
circuit panel
Open a support case -
Motor does not
work
The motor automatically
stops working when used
more than 5 times in a row
Allow motor to rest for an
hour
Faulty control panel or
circuit panel
Open a support case -
Contents not heated
Faulty heating element
Open a support case -
Faulty control panel or
circuit panel
Beans, nuts, grains
not well milled
Too many or too few
beans/nuts added
Use the measuring cup
included in the box and
follow instructions
Too much or too little
water added
Fill the water between the
MIN and MAX levels
The machine is defective Open a support case -
TROUBLESHOOTING
3
SAFETY PRECAUTIONS
This product should not be used by children. Read the
instructions before operating, cleaning or using the appliance
carefully.
1. Before you connect the appliance to the power, make sure
that the voltage indicated on the appliance corresponds to
the local power voltage.
2. Do not use this appliance on an unstable or uneven surface.
3. This appliance can only be used with a grounded plug. Make
sure that the plug is properly attached to the power outlet.
4. The appliance is intended for household use only.
5. Do not use a power cord or plug that is damaged. Check the
cable before use, if damaged, immediately discontinue use.
Only use the cord supplied with the machine. Contact
customer service for replacement parts.
6. Do not get the power cord connector wet. If it gets wet
accidentally, it must be dried before using.
7. Remove the plastic pitcher from the barrel and clean the
Chamber Unit prior to using the machine.
8. To prevent a short circuit or an electric shock, do not use
water to rinse the outside of the Chamber Unit, or Head
Unit (including the head unit handle, control panel, upper
plug, upper plug connector, and the power cord connector)
and keep them away from any liquid drip or splash.
9. Do not place the head unit or base of machine in water.

4
SAFETY PRECAUTIONS (CONTINUED)
10. Use this device on a flat hard surface. Do not use on a
flammable surface such as carpet. Allow plenty of room on
all sides for ventilation.
11. Clean the Chamber Unit and Overflow Sensor regularly.
12. Do not run several cycles in a row with the same contents.
This may cause overflow and warning alarm. To protect the
motor and prolong the life of it, a break of at least one hour
is recommended after each use .
13. The appliance should always be placed out of the reach of
children while plugged in.
14. This appliance utilizes high-speed motor at random intervals.
Do not be alarmed when the machine seems to start and
stop during the process.
15. If power is turned off while the appliance is operating, do
not press the function keys. This will lead to overcook and
overflow.
16. Do not lift the Head of the appliance during operation.
17. Do not use this machine to boil water, or for dry heating, or
to heat up food or drinks.
18. Make sure to add water between the MIN and MAX fill lines
to avoid overcooking and overflowing.
13
Cream of Pumpkin, Squash or Zucchini Soup
Ingredients
6 measuring cups of diced pumpkin, squash or zucchini
1 carrot diced into small cubes
1 measuring cup of uncooked rice
1 celery stalk diced into small pieces
Tap water between the MIN and MAX lines
Directions
1. Place all ingredients, in the order listed, into the barrel.
2. Press the PUREED SOUP function button and wait about 30
minutes.
3. When the cycle completes, add salt to taste and garnish with
parsley
Peanut Corn Juice
Ingredients
2 measuring cups of fresh corn kernels
2 measuring cups of raw peanuts
Tap water between the MIN and MAX lines
Directions
1. Soak peanuts for 2 hours in water and drain
2. Add ingredients to the barrel
3. Push the CORN JUICE button and wait about 30 minutes for
the cycle to complete.
4. Pour the juice through the filter and chill before serving.

12
RECIPES
Check our website—idavee.com—for new recipes!
Vanilla Soymilk
Make soymilk according to the instructions. Once the cycle is
complete, add 1/2 tsp sea salt, 1 tsp vanilla extract, 3 tablespoons
cane sugar to hot milk. Stir thoroughly and chill before serving.
Don’t be afraid to experiment. Try other flavorings in place of
vanilla and other sweeteners instead of sugar. Agave Nectar,
molasses, brown rice syrup are some examples.
Onion Broccoli Soup
Ingredients
1 red or yellow onion
2 cups broccoli florets
2 carrots, diced into small pieces
1 tsp pepper
Tap water between MIN and MAX lines
2 tsp sea salt
Pinch of grated nutmeg
Dash of olive oil
Fresh parsley for garnish
Directions
1. Add onion, broccoli, carrots, and pepper to the chamber.
2. Add water between the MIN and MAX lines
3. Attach the head unit to the chamber and press the PUREED
SOUP button.
4. When the cycle is complete, pour soup into a bowl and add
the remaining ingredients, adding the olive oil last.
5. Serve hot, garnished with parsley
5
19. Never leave the machine unattended while operating.
20. To avoid burns, do not touch the metal parts while the unit is
operating.
21. Disconnect the power cord from the outlet and the device
before lifting the machine Head.
22. Unplug the appliance and remove the cord when not in use
and before cleaning.
23. Do not let the cord hang over the edge of a table or counter,
or touch hot surfaces, such as the stove.
24. Do not place the device on or near a gas or electric stove
burner or in an oven.
25. Use extreme caution when moving the device if it contains
hot liquids as its contents may spill.
26. Add sugar and other sweeteners after the machine completes
the process to prevent burning.
27. Clean the device thoroughly after each use.
28. The blades are sharp, handle with care. Use the included
cleaning pad or brush to clean the blades.
29. Do not use harsh chemicals such as alcohol or bleach to clean
the machine.
30. Do not use steel wool or wire brushes to clean the unit as
this will scratch the delicate surface.

6
PARTS IDENTIFICATION
4. RECEPTACLE
2. CONTROL PANEL
5. OVERFLOW
SENSOR
6. BLADES
9. BARREL
1. HEAD HANDLE
7. BARREL CONNECTOR
3. HEAD
10. MIN AND MAX LINES
8. BARREL HANDLE
11. POWER PLUG
4.
3.
5.
1.
6.
2.
11
CLEANING AND STORAGE
You can clean your machine with the self clean function or
manually.
Self Clean Function
1. Fill the barrel with tap water between the MIN and
MAX lines. Never add soap to cleaning function.
2. Position the machine head connector into the barrel
connector.
3. Connect the power cord to the device, and then
connect to the socket.
4. Press the JUICE/CLEAN button.
This process takes about five minutes. The machine will
beep continuously when the cycle is complete.
Manual Cleaning
1. Disconnect the power cord from the machine and
the outlet.
2. Do not immerse the head of the appliance in water.
3. Use a mild dish washing soap to clean the unit, never
use abrasive cleaners as they will damage the surface.
4. Wash the inside of the barrel with water and use the
cleaning pad to remove debris.
5. Clean the outside of the machine with a damp cloth.
Never rinse the outside, top or bottom of the unit
with water.
Storage
Disconnect and clean the appliance. Dry all parts with a
cloth. Store in a dry and ventilated place after cleaning.
Excess humidity may reduce the life of the machine.
Never store the appliance when it is still hot or plugged
in. Do not tightly wrap the cord around the appliance.

10
OTHER NOTES
This appliance is equipped with a function lock that will lock
automatically 3 seconds after the function button is pressed.
If you need to change to another function after pressing the
wrong one, you will need to unplug the machine from power
to start another function.
After the contents have cooled, do not use this machine to
reheat the milk/juice. This will cause the milk to burn to the
heater.
Do not use cheese or sugar products in the heated functions,
this will also burn to the bottom of the stainless steel barrel.
Here are some recommendations for the amount of ingredients
to use each time. Do not use more or less than indicated.
Dry beans/nuts/grains: 1 measuring cup
Soaked beans/nuts/grains: 2 measuring cups
Porridge/Oatmeal: 2 measuring cups
Rice Soy Milk: 40g soybeans, 60g rice
Corn Juice: 6 measuring cups of fresh corn
Soup and Juice: 6 measuring cups of 1/2 inch diced
ingredients
7
MACHINE PARTS
1. Head Handle: For lifting the machine head from the barrel.
2. Control Panel: Press the desired function button and the
machine will start the automatic process.
3. Head: The main part of this appliance. Includes motor,
computer board, etc.
4. Receptacle: Used for connecting the power cord.
5. Overflow Sensor: Used for detecting and preventing the
contents from overflowing.
6. Blades: For mixing and grinding the machine’s contents.
7. Barrel Connector: Used for connecting the head to power.
8. Barrel Handle: For lifting the barrel.
9. Barrel: Double layer stainless steel body for heat and sound
resistance.
10. Min and Max Lines: Markers for correct water levels.
11. Power Plug: Connect female end of plug here and male end
into power outlet.
ACCESSORIES
1. Pitcher
2. Filter
3. Scrubbing Pad
4. Measuring Cup
5. Cleaning Brush
6. Power Cord

8
QUICK REFERENCE
9
DIRECTIONS FOR USE
Use the enclosed measuring cup to measure the correct amount
of rinsed beans, nuts or grains.
1. For DRY BEAN/NUT function, 70 grams (one measuring
cup) of dry beans or nuts is needed.
2. For WET BEAN/NUT function, 140 grams (two measuring
cups) of soaked beans or nuts are needed. Beans and nuts
should soak for at least 8 hours in room temperature water.
3. Rinse the beans, nuts or grains before placing into the barrel.
4. Fill the barrel with room temperature tap water between
the MIN and MAX lines as shown in FIG 2. Using distilled or
purified water will result in over-boiling causing burnt taste.
5. Place the machine head receptacle on the barrel connector
as shown in FIG 3.
6. Connect the power cord to the device, and then plug it into
the outlet. The device beeps and the cycle indicator lights
will flash.
7. Press the desired function button, the device beeps, and the
selected button light turns on and stays lit.
8. Three seconds later, all the buttons are automatically locked
and the engine will start to heat.
9. The heated functions take an average of 30 minutes. The
JUICE/CLEAN function takes about 8 minutes —FIG 7.
10. The machine will beep continuously when the cycle is
complete.
11. Unplug the power cord from the power outlet first, and
then remove it from the machine —FIG 8.
12. Place the filter on top of the included plastic pitcher.
13. Raise the head off the barrel —FIG 9, pour milk over the
filter into the pitcher —Fig 10.
14. Add desired sweeteners and/or flavoring and chill milk.
Should last up to 5 days in the refrigerator.
Table of contents