IDEAL CXS 40 User manual

USER’S
IDEALIDEAL
IDEALIDEAL
IDEAL
THETHE
THETHE
THE
GUIDE
Concord
CXS 40 - 120
User’s guide to commercial central heating boilers

2Concord CXS 40-120 - User's Guide
CONCORD CXS 40 - 90 models only
ALL MODELS
THE GAS SAFETY (INSTALLATION AND
USE) REGULATIONS 1994 impose certain
statutory obligations on gas users. This
appliance must be installed by a Corgi
registered installer.
WARNING.
This appliance MUST be efficiently earthed
1. It is ESSENTIAL that the instructions in this booklet
are strictly followed, for safe, economical operation of
the boiler.
2. Do not obstruct ventilation ducts, grilles or openings in
the boiler room, or the passage of combustion and
ventilation air to the boiler.
3. Do not store objects around or on the boiler, and keep
access clear at all times.
4. Switch off and disconnect the electricity supply before
carrying out maintenance work.
5. Do not turn off the boiler if it is to be left unattended in
frosty weather.
MAINTENANCE
The appliance should be serviced at least once a year by
a CORGI registered installer.
CLEANING
For normal cleaning simply dust with a dry cloth.
To remove stubborn marks and stains use a damp
cloth and mild detergent.
DO NOT use abrasive cleaning materials.
LEGEND
1. Thermostat knob
2. Control box
3. Mains inlet gas cock
4. Overheat thermostat
reset button
8
3
3
4
5. Boiler on light
6. Lockout light
7. Lockout reset button
8. Overheat light
9. Gas control valve
2
9
Knob setting Approx flow Approx flow
setting temp οο
οο
οC temp οο
οο
οF
1 60 140
2 65 149
3 70 158
4 75 167
5 80 176
6 85 185
CAUTION. To avoid the possibility of injury during the use or cleaning of this
appliance care should be taken when handling edges of sheet steel components.
7
6
5
1
8

3
Concord CXS 40-120 - User's Guide
CONCORD CXS 100 - 120 models only
TO SHUT DOWN THE BOILER
For short periods
Turn the boiler off at the time clock or system controls. Wait 6
min. and then turn the boiler control thermostat knob (1) to
OFF. Note the frost warning below.
For long periods
Turn the boiler off at the time clock or system controls. Wait for
6 min. and then turn the boiler control thermostat knob (1) to
OFF. Note the frost warning below.
TO RELIGHT THE BOILER
After short periods
Switch on the time switch or system controls and turn boiler
thermostat knob (1) to the required setting. The boiler will light
providing the external controls are calling for heat.
After long periods
Follow the lighting instructions above. Refill the system if it has
been drained.
FROST WARNING
If frost is likely, leave the boiler thermostat at position 6 and do
not turn off the gas cock.Tthis will enable the built -in frost
thermostat to protect the boiler. Note that this may not protect
remote parts of the system, in which case a seperate frost
thermostat should be fitted or the system drained and the
boiler shut down for as for long periods.
1. Check that the boiler thermostat knob (1) on the control
box (2) is OFF.
2. Ensure that the mains gas inlet cock (3) is open (groove
in the square head in line with the gas pipe).
3. Press in and release the overheat thermostat button (4).
4. Switch on the electrical supply to the boiler.
5. Ensure that all system controls (time switch, system
controls etc.) are calling for heat.
6. Turn the boiler thermostat knob (1) to position 6.
7. The boiler will light at Low rate and the Boiler-on light (5)
will be illuminated. If it does not light the Lockout light
(6) will be illuminated. Press in and release the Lockout
button (7). The controls will reset and attempt to relight.
8. The burner will remain at Low rate for about 3 minutes
before going to High rate.
9. Check all connections for gas soundness, using leak
detection fluid.
10. Set the boiler thermostat knob and the system controls
to the required settings.
11. Turn off the electrical supply to the boiler.
TO LIGHT THE BOILER
9
3
3
4
29
LEGEND
1. Thermostat knob
2. Control box
3. Mains inlet gas cock
4. Overheat thermostat
reset button
5. Boiler on light
6. Lockout light
7. Lockout reset button
8. Overheat light
9. LH Gas control valve
10. RH Gas control valve
10
10
7
6
5
1
8

Caradon Plumbing Limited, P.O. Box 103, National Ave, Kingston upon Hull, HU5 4JN. Telephone:
01482 492 251 Fax: [phone]. Registration No. London 322 137. Registered Office: National
Avenue, Kingston upon Hull, HU5 4JN. A subsidiary of Caradon plc
Caradon Plumbing Limited pursues a policy of continuing
improvement in the design and performance of its
products. The right is therefore reserved to vary
specification without notice.
Technical Training
The Caradon Plumbing Limited Technical Training Centre
offers a series of first class training courses for domestic,
commercial and industrial heating installers, engineers and
system specifiers.
For details of courses please ring: ........... 01270 413 624 April 2000 154 871 A01
Ideal Installer/Technical Helpline: 01482 498376