Idis DC-TH Series User manual

Thermal Network
Camera
Quick Guide
DC-TH Series

2Thermal Nerwork Camera Quick Guide
NVR Registration
1. Supply power to the camera using 12V input
or POE cable. Synchronize the network same as
the computer.
3. Select the camera and click Device web.
(You can access directly by entering 192.168.0.
100 without IP installer)
2. Run IP installer and select Search button to
scan the thermal camera with the same network.
(Camera default IP address: 192.168.0.100.
Set the computer with the same e.g.)
192.168.0.10)
4. Enter the camera ID and Password
(Default : admin / Thermal#)

3DC-TH Series
5. Set the camera to allow people to have the
highest temperature and check the temperature
at the bottom right when person is detected
from one meter distance.
7. Enter Video - Live Screen Setup, and set
Event Report [ON]
6. Select SETUP button.
8 . Click Event Max Temperature and enter the
temperature of 2°C higher than the person
identied in 5. (e.g. in environment where a
person is detected at 32°C, set the upper alarm
limit to 34°C.)

4Thermal Nerwork Camera Quick Guide
9. Connect the camera to the NVR and select
camera registration by clicking on the right
mouse button.
11. Select Advanced Setup.
10. Scan - Select Third Party Scan.
12. Change the mode to Manual.

5DC-TH Series
13. Set the same netowrk address with NVR and
camera.
(If camera IP address is 192.168.0.100,
set NVR IP address 192.168.0.200)
15. Select IP address mode , enter camera IP
address and scan.
(If camera IP adress is set as default ,
enter 192.168.0.100).
14. Select Onvif Comformance Protocol.
16. If scan is done, close Thrid Party Scan,
right click and select add camera.

6Thermal Nerwork Camera Quick Guide
17 . Enter camera ID and password , then cam-
era is registered and live view is available. Select
Apply button and camera registration is done.
(Default : admin /Thermal#)
19. Camera - Set the stream 1 resolution
800 x 600 and apply.
(1280x1024 with DC-TH2012WR)
18. Select the Setting.

7DC-TH Series
1. Select the Setting.
3. Select the Alarm out. 4. Select Beep, click ok and apply. NVR triggers
beep sound when temperature is detected.
2. Enter Event - Video Analysis - Motion,
select Actions
Temperature MAX Alarm Setting

For more information, please visit
www.idisglobal.com
IDIS and identifying product names and numbers herein are registered trademarks of IDIS Co., Ltd. All non-IDIS brands and product names
are trademarks or registered trademarks of their respective companies. Product appearance, build status, and/or specications are subject to
change without notice. Copyright © IDIS Co., Ltd. All rights reserved.