IFB Digital User manual

OPERATING MANUAL
Advancing the science of washing
7kg
All manuals and user guides at all-guides.com
all-guides.com

All manuals and user guides at all-guides.com

1
All manuals and user guides at all-guides.com

2
All manuals and user guides at all-guides.com

3
All manuals and user guides at all-guides.com

4
All manuals and user guides at all-guides.com
all-guides.com

5
All manuals and user guides at all-guides.com

6
All manuals and user guides at all-guides.com

7
All manuals and user guides at all-guides.com

Part 4: Program Selection and Washing Machine Operation
Insert the plug. Press the On/Off button and then the Door open button. Open the door. Place your laundry into the machine according
to the recommended load capacity and close the front door.
Select the program according to the dirt strength and the thermostat value by means of Program Selection Table given on the
following Pages.
Then, fill the fabric softener and the detergent into related compartments, and close the detergent dispenser box. Push the
Start/Cancel/Pause button to operate your machine. In the mean time the Start/Cancel/Pause LED will be on. You can follow
the washing steps by means of the program follower
1
5
9
2
6
10
3
7
11
8
8
All manuals and user guides at all-guides.com

9
All manuals and user guides at all-guides.com
all-guides.com

10
All manuals and user guides at all-guides.com

11
All manuals and user guides at all-guides.com

12
All manuals and user guides at all-guides.com

13
All manuals and user guides at all-guides.com

Part 5: Care and maintenance
To clean the detergent residues, remove the detergent dispenser
from its place by pressing on the area marked on siphon. Wash the
dispenser with water and also clean the dispencer housing before
inserting the dispenser to its place.
Clean the siphon (coloured piece in the dispenser) every 30-40
washes. Pull out the siphon by holding from its edges. To prevent
clogging, clean the softener residues thoroughly and make sure that
the siphon fits into its place completely before any operation.
At the end of the water intake connection module and water inlet
hose-tap side, there exists filters. These filters prevent any dirt
and objects passing into the machine. It is advisable that these
filters should be cleaned every 30-40 washes. To clean the filter,
first turn the tap off. Then, disconnect the hose and clean the
filter with thin brush. If the filter is very dirty, you may clean it
by pulling out with pliers. To clean the filter at the tap side of the
hose, pull it out by hand and clean the filter under the tap water.
To prevent any leakage, have a technician to control the hoses
every two years. If the machine is placed at cold ambient
temperatures, the water remaining inside the pump and hoses
should be removed from the filters. Also to prevent freezing,
empty the water intake hoses by disconnecting from taps.
Do not leave any metal objects (pins,needles,etc.)inside the
drum. These objects may cause rust on the drum surface. Do not
clean the drum with scratching elements.
Detergent dispenser
Siphon
Water intake filter
Hose
Drum
14
All manuals and user guides at all-guides.com
all-guides.com

15
All manuals and user guides at all-guides.com

16
All manuals and user guides at all-guides.com

17
All manuals and user guides at all-guides.com

18
All manuals and user guides at all-guides.com