iGenix IG2615 User manual

USER MANUAL
IG2615 / IG2620 / IG2625
Oil Filled Radiators
For models:
PO Number:
Please read these instructions carefully before use and retain for future reference
Before switching on you appliance
Always check for any damage which may have been caused in transit
IMPORTANT: THIS PRODUCT IS ONLY SUITABLE
FOR WELL INSULATED SPACES OR OCCASIONAL USE

2
CONTENTS
Safefty instructions..................................................................3-4
Appliance Overview...................................................................5
Operating Instructions...............................................................6
Cleaning and Maintenance ........................................................7
Fuse Replacement.......................................................................7
Product disposal and recycling.................................................7
Igenix Warranty .......................................................................8-9

3
SAFETY INSTRUCTIONS
WARNING: In order to avoid overheating, do not cover
the heater.
1. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or a similarly qualied person in
order to avoid a hazard.
2. This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and un- derstand the hazards involved.
Children shall not play with the appli- ance. Cleaning and
user maintenance shall not be performed by children without
supervision.
3. The heater must not be located immediately below a socket-
outlet.
4. Do not use this heater in the vicinity of a bath, shower or
swimming pool (or other body of water)
5. Children of less than 3 years should be kept away unless
continuously supervised.
6. Children aged from 3 to 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its
intended normal operating position and they have been given
supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Children
aged from 3 to 8 years shall not plug in, regulate and clean the
appliance nor perform user maintenance.
7. CAUTION: Some parts of this product can become
very hot and cause burns. Particular attention must
be given where children and vulnerable people are
present.

4
8. This heater is lled with a precise quantity of special oil. Repairs
re- quiring opening of the oil-container are only to be made by
the manufacturer or his service agent who should be contacted
if there is an oil leak.When scrapping the heater, follow the
regulations concerning the disposal of oil.
9. Correct Disposal of this product
This marking indicates that this product should not be disposed
with other household wastes throughout the EU.To prevent
possible harm to the environment or human health from
uncontrolled waste disposal, re- cycle it responsibly to promote
the sustainable reuse of material re- sources.To return your used
device, please use the return and collec- tion systems or contact
the retailer where the product was purchased.They can take this
product for environmental safe recycling.
10. This heater cannot achieve accurate temperature control of the
enviroment, and thus cannot be used as insulation device for
storage environment, items, animals and plants.

5
APPLIANCE OVERVIEW
Power Switch Knob
Cord Wrap
Fin
Mounting the Castors
1. Turn the heater upside down.
2. As shown in gure 1, align the mounting hole of the caster assembly and install it on the screw of the caster
pad plate at the end of the radiator n. The other caster assembly is aligned to the screws mounted at the
bottom of the control box.
3. As shown in gure 2, tighten the two sets of caster assemblies with four buttery nuts. Tighten the nuts and
then return the heater to an upright position with the wheels on the ground.
Figure 1 Figure 2
Buttery Nuts
Control Box
Castor Assembly
Thermostat Knob

6
OPERATING INSTRUCTIONS
Inspection before operation
1. Check that the power cord is not damaged or fractured.
2. Please verify the rated current of the power socket is in line with the requirements on the rating label and
is equipped with a safety grounding device before use; otherwise, replace the socket.
Start and Power Selection
1.Start
• Plug in the power and turn the thermostat knob clockwise to the “+” mark position.
• Turn on the power switch and the heater will begin to operate.
2.Power Selection
Under normal circumstances please use the maximum power “III” gear for rapid heating. If the room
temperature reaches a suitable temperature, please choose a lower power “II” or “I” gear to reduce energy
consumption and to prevent the room becoming overheated.
Inspection method
Insert the power plug into the socket and turn the heater on. After about half an hour turn off and pull out the
plug. Check whether the plug pins are hot. Replace the socket if it is more than about 50 °C to avoid burning
the plug or causing a re caused by overheating of the socket due to poor contact.
Temperature adjustment
During use, if you feel it is necessary to lower the room temperature since it is too high, you can use the
following adjustment modes:
1. Turn the power switch to gear “II” or “I”.
2. Turn the thermostat knob counterclockwise to set the temperature lower. The temperature is lower
when the indication is closer to the “ - ” position.
Stop
Turn the power switch to point “0” and then pull out the power plug.
Movement of the heater
To move the heater, turn it off rst, and pull out the power plug; then push the body using the four casters at
the bottom of the unit.

7
Fuse Replacement (Class I)
This appliance must be earthed. Remove the central screw on the plug and
open the shell.Take out the fuse and replace with a new fuse of the same Amp.
Install the shell again and tighten the screws.
MAINS PLUG FUSE REPLACEMENT
Before attempting any cleaning or maintenance on the radiator, allow it to cool completely and ensure
that the plug is removed from the socket.
1. The electric heater should be cleaned regularly to wipe out the dust on the surface of anges as this
may inuence the radiating efciency.
2. Disconnect electricity supply and allow radiator to cool, wipe out dust with a soft damp cloth. Do not
use detergent or abrasives.
3. Do not scrape the surfaces of the anges with sharp hard tools in order to avoid surfaces getting rusty
due to damage to the paint coat.
CLEANING AND MAINTENANCE
DISPOSAL INFORMATION
The European Directive 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE), requires that old household
electrical appliances must not be disposed of in normal unsorted
municipal waste.
Old appliances must be collected separately in order to optimise
the recovery and recycling of the materials they contain and reduce the impact
on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your
obligation, that when you dispose of the appliance it must be separately collected.
Consumers should contact their local authority or retailer for information
concerning the correct disposal of their old appliance.

8
Igenix Warranty Terms & Conditions
This product is guaranteed for a period of 12 months as standard from the date of purchase
against mechanical and electrical defects.You can extend your warranty for a further 12 months by
registering your product.
Upon registration we will cover your product for a period of 24 months from the original purchase
date against any mechanical or electrical defects.
To qualify for the warranty, the product must be used for domestic household use only and in
accordance with the instructions in the user manual.Any misuse of the product will result in the
warranty being void.
The warranty does not cover accidental damage, misuse, neglect, tampering or incorrect adjustment
or installation.
The warranty will be rendered invalid if the product is resold, has had its serial number removed
(or has an invalid serial number), or if an unauthorised person has carried out any repairs or
alterations.
The warranty does not cover accessories or consumable parts that require replacement under
normal use. This includes shelving, dials, lters, belts and trays etc.
In the unlikely event of a breakdown please refer to the Troubleshooting guide in your user manual
and check all plugs, fuses and the electricity supply.
If you still require assistance please contact our Customer Service department on
01473 271 272 or write to us at the following address:
Customer Service Department
38 Bluestem Road, Ransomes Europark
Ipswich, IP3 9RR
Please quote the Product Code which begins ‘IG’ or ‘DF’ and the PO Number on the front of the
manual, and give details of the exact fault.We will then decide whether to repair or replace the
item.
Before we arrange the repair or replacement you will be required to return a copy of your proof
of purchase. Please retain your original.
If an item is replaced within the agreed warranty period, the warranty for the replacement item will
be calculated from the purchase date of the original.
In the event that the product is inspected and no fault is found or the product is not within the
warranty period you will be charged for the repair and any carriage costs.

9
Thank you for choosing lgenix
As a valued customer we would like to offer you a FREE 2 year warranty to cover your product
against any electrical or mechanical defects.
This means that in the unlikely event you develop a fault or problem with your product we will
happily repair or replace the item free of charge.
To qualify for the 2 year warranty you must register your product within 30 days of purchase.The
full Terms & Conditions of our warranty policy are shown on the opposite page.They are also
available on our website. www.igenix.co.uk

10

11

38 Bluestem Road, Ransomes Europark, Ipswich, IP3 9RR
Tel. [phone]
Disclaimer: Igenix operate a policy of continual improvement and development.
We therefore reserve the right to change/alter the specication and appearance of our appliances without prior notice.
All diagrams and images shown in this manual are for illustration purposes only.