II Morrow Inc. Apollo NMC 2001 User manual

Enroute
Within 30 nm
of Destination
IAF Active
Waypoint
FAF Active
Waypoint
At FAF (MAP
Becomes
Active)
At MAP
(TO/FROM
Transition)
MAHP Active
Waypoint
Approach Checklist
Load Approach
Enable Approach & enter altimeter
setting
(Approach annunciator turns ON)
(CDI goes to 1 nm full-scale sensitivity)
Verify Approach annunciator is ON
Set OBS/HLD: ON for Procedure
Turn or Hold
OFF to sequence
Verify green Approach-Active
annunciator is ON
Verify altimeter setting is entered
Set OBS/HLD: OFF to sequence
to MAP
Verify Approach-Active annunciator
is ON
(CDI goes to 0.3 nm full-scale
sensitivity)
If NOT landing: Press OBS/HLD to
cancel Approach-Active
(Green Approach-
Active annunciator turns OFF)
(Approach Annunciator remains ON)
(CDI goes to 1.0 nm full-scale sensitivity)
Verify OBS/HLD is ON
Location Action
Apollo NMC 2001/2101

At Arc Intercept
On Arc
Inbound Leg
Intercept
DME-Arc Checklist
1. Verify/Set OBS/HLD ON
2. Manually select Flight Plan
leg to intercept
3. USE DME-Arc Page in
NAV mode
4. Verify or select DME-Arc
Reference Waypoint
5. Verify/Set autopilot in Heading
mode or disengaged
1. Use DME-Arc page in NAV
mode and aircraft heading to
navigate
2. Use CDI/HSI to identify
inbound leg intercept
1. Set/Verify OBS/HLD OFF
2. Use CDI/HSI to navigate
3. Press NAV twice to use
standard NMC NAV mode page
4. Use autopilot as desired
ActionLocation
VISIONARY THINKING TODAY
II MORROW
P/N 561-1039-00
April 1996
http://www.iim.ups.com
2345 Turner Rd., S.E.
Salem, OR 97302
USA Toll-Free 800.742.0077
Apollo NMC 2001/2101