iKAMPER Mounting Bracket Lock User manual

Mounting Bracket Lock Installation
The mounting bracket locks will give you peace of mind, deterring anyone from taking the Skycamp
off your vehicle. One lock goes on each crossbar, and the locks block access to the nuts.
Please follow these instructions for an optimal installation.
Included parts:
-2 bracket locks (1 top and 1 bottom piece each)
-2 keys
-8 rubber pads

STEP1
Step 1: When using the mounting bracket locks, the 2nd bolt can be used in holes 3 and 4 only. Place the
second bold in one of these two holes, closest to your crossbar.
STEP2
Step 2: Slide the top bracket into the rail under the Skycamp, so that one bolt is on each side of the
crossbar.

STEP3
Step 3: Take the top piece of the mounting bracket lock and place it over the bolts. NOTE: this piece
replaces the standard bottom bracket piece.
STEP4
Step 4: Tighten the nuts, on one bolt, then the other, going back and forth. NOTE: apply lubricant to
the bolts and nuts before tightening to reduce the risk of thread galling.

STEP5
Step 5: Place 1-2 rubber pads between the Skycamp rail and lock before completely tightening the
nuts.
STEP6
Step 6: Once the nuts are securely tightened, place the bottom piece of the mounting bracket locks
over the nuts and secure in place by twisting the locks on each side.

STEP7
Step 7: Twist the hand-tightening nut to insure the bottom bracket piece is tight.
STEP8
Step 8: One crossbar done! Now repeat the process with the second lock on your other crossbar.