
Design and specifications are subject to change without notice.
Ikegami IKEGAMI ELECTRONICS (U.S.A.). INC.
■Headquarters
37 Brook Avenue, Maywood, NJ 07607 TEL.(201)368-9171 / FAX.(201)569-1626
■West Coast Office
2631 Manhattan Beach Blvd., Redondo Beach, CA 90278 TEL.(310)297-1900 / FAX.(310)536-9550
■Southwest Office
773 Bearden, Waxahachie, TX 75167 TEL.(972)869-2363 / FAX.(972)556-1057
■Midwest Office
747 Church Road Unit C1, Elmhurst, IL 60126 TEL.(630)834-9774 / FAX.(630)834-8689
■Southeast Office
5200 N.W. 33rd Avenue Suite 111, Ft. Lauderdale, FL 33309 TEL.(954)735-2203 / FAX.(954)735-2227
H18A998-SI-F1 Printed in Japan
∗NTSC versions are no available with CE Mark.
PM9050
■
Dimensions
■
Specifications
■GENERAL
Power AC100V〜240V
50/60Hz, approx. 30W or less
Ambient Temperature 0°C〜+40°C(32°F〜104°F)
90% or less relative humidity
External Dimension 220×215×255mm
(W×H×D)
Weight Approx. 4.4kg
Connector Video input : BNC type(2 systems)
Sync input : BNC type(1 system)
Remote input
Tally input
Front Panel Controls Power ON/OFF
Video input A/B
Sync input EXT/INT
Size NOR/WIDE
Pulse cross ON/OFF
4:3/16:9
Contrast
Brightness
Remote Operation Video input A/B
Sync input EXT/INT
4:3/16:9
RED tally ON/OFF
Acquired Safety CE
Standard
Standard Accessories Remote connector, AC cable, Operation Manual
■RATING
Input Signal 2 video inputs
1 sync input
Input Level Video signal : VS 1.0Vp-p or
V 0.7Vp-p, positive
Sync signal : 0.3V〜0.8Vp-p, negative
Input Impedance Video input/Video sync : 75Ωterminated or
high impedance bridge connection
Output Level 25Vp-p
CRT E8069B4
Phosphor Colorimetry 6500°K
Brightness 60ft-L
Operation Continuous
Scanning Size Normal Scan : W160 ×H120mm
<4:3 mode> Wide Scan : Area of 4:3 aspect ratio where the
picture height touch to the top and
bottom of escutcheon
<16:9 mode> Normal Scan : W160 ×H90mm
9-inch Broadcast Monochrome Monitor
221±4
465±1.5
128.5±3
37.7±1146.1±1
221.5±4
483±1.5
■PERFORMANCE
Horizontal Resolution 800TV Lines or more at center
Power Voltage Will maintain stable picture quality with a ±10% AC
Fluctuation input voltage fluctuation
X-ray Radiation Less than 0.1mR/H under normal operation
at the place 50mm away from monitor
(should not be over 0.5mR/H even when damaged)
■VIDEO Signal System
Frequency Response 50Hz〜10MHz : Within +1/-3dB
Over 10MHz : Falling
From video input terminal to CRT drive output
referred to 100kHz under the rated output
Max. Gain Approx. 35dB or more
Gain (contrast) Continuously variable from 0 〜max. gain
Adjustment
■DEFLECTION SYSTEM
Scanning Frequency
Horizontal 15.625kHz(PAL) 15.75kHz(NTSC)
Vertical 50Hz(PAL) 59.94Hz(NTSC)
Sync Stability
* Stability of synchronization will be met for the following conditions;
Internal Sync VS level change ±6dB from the rated value
when chroma level is kept at 150%
External Sync 0.3V〜8Vp-p
Scanning Amplitude Must be adjusted to the rated size of 4:3 or
16: 9 aspect ratio
Deflection Distortion Less than 1% both for
deflection linearity and raster distortion
Pulse Cross Display Horizontal(H) : Approx. 1/4 shift
Function Vertical(V) : Approx. 1/2 shift
Hum Oscillation 0.2mm or less
■HIGH VOLTAGE
Tolerance Approx. 12KV±1KV(cut off)
Regulation Less than ±3% over the range of 0 to 200μA
referred to 100μA
■DUAL UNITS
φ14
M3BR φ24 180±1148±1
220±2
215±2
123±2
2
47±2
255±4
Unit:mm
REAR VIEW SIDE VIEW FRONT VIEW