Ikelite 5509.34 Quick start guide

Zoom Gear for Sony FE 24-70 mm F2.8 GM
Product Number - 5509.34
Included in the Box
• Sony Lens Ring # 0098.32
• Port Gear Sleeve # 0073.51
• Clamp # 9059.9
Installation and Use
Attach the Sleeve, Adapter and Clamp
1. Rotate Gear Sleeve Retainer counterclockwise and
remove using Gear Sleeve Retainer Tool.
2. Place Port Gear Sleeve into the housing Port Mount
opening.
3. Tighten Gear Sleeve Retainer into Port Mount using Gear
Sleeve Retainer Tool. Tighten clockwise so Retainer is
snug - Diagram A. DO NOT overtighten.
4. Slide Sleeve Adapter Small Slots into Gear Sleeve Posts
- Diagram B.
5. Gently expand and place Clamp over front of lens. Push
Clamp down to lens position shown - Diagram C.
6. Line up the two red dots on the camera face and bayonet
end of the lens.
7. Rotate lens focus ring until Clamp Tabs line up with
Sleeve Adapter Large Slots.
8. Lower lens and bayonet onto the camera body by rotating
lens clockwise - Diagram C.
9. Push clamp down on the lens until the Clamp Tabs slide
fully into the Sleeve Adapter Large Slots.
10. Rotate housing knob to check focus function.
11. Install Lens Port.
Diagram A
Diagram B
Gear Sleeve
Post
Gear Sleeve
Port Mount
Gear Sleeve Retainer Tool
Gear Sleeve
Retainer

Limited Warranty
This Ikelite product is warranted against any manufacturing
defects for a period of one (1) year from the original date
of purchase. To obtain warranty service, the product must
be returned to Ikelite postage paid. Ikelite will, at its sole
discretion, repair or replace such products, and will return
to customer postage paid. All other claims of any nature are
not covered. Except as mentioned above, no other warranty
expressed or implied applies to this Ikelite product.
Diagram C
5509.34_Sony_FE_24-70_F2.8_GM_1-0218
Sleeve Adapter
Large Slots
Clamp TabsClamp
Lens
© 2018 Ikelite Underwater Systems
Ikelite.com