Ikelite 5509.68 User manual

5509.68 Zoom Sleeve
INSTALLATION INSTRUCTIONS or
Sigma 8-16mm F4.5-5.6 DC HSM Lens
Diagram A
5509.68 oom Sleeve
Black Housing Gear
Sigma 8-16mm Lens

Detachment Procedure
1. Remove housing port.
2. Depress camera lens release button using housing control.
Refer to your Ikelite housing manual for proper port installation.
3. Rotate lens counterclockwise off camera and gently wiggle
oom Sleeve up lens barrel to remove.
4. Reattach lens to camera.
2
Installation Procedure
1. Install the camera and lens in your Ikelite housing.
2. Place the oom Sleeve over the lens and gently wiggle sleeve
down the lens barrel (Diagram A, front page).
3. Push down on top of oom Sleeve above Black Housing Gear
while rotating the housing oom Control (Diagram C, page 3).
Rotate until oom Sleeve Teeth mesh with Black Housing Gear
teeth (Diagram B & C, page 3).
4. Using your thumbs, gently push down around the entire top of
the oom Sleeve perimeter until it is properly seated in the
housing opening (Diagrams B & C, page 3).
5. Install housing port. Refer to your Ikelite housing manual for
proper port installation.
6. Check function by rotating housing oom Control (Diagram C,
page 3).

3
Lens and Zoom Sleeve properly installed
Diagram C
IKELITE
Black Housing Gear
5509.68
oom
Sleeve
Diagram B
5509.68
oom Sleeve
Sigma 8-16mm Lens
Lens
Mesh Gear Sleeve
Teeth with Black
Housing Gear Teeth
Before Installing Port
Black Housing Gear
oom Control

5509.68_ oom_Sleeve_Installation_Sigma_8-16mm_1-0911
Ikelite Underwater Systems
50 West 33rd Street
Indianapolis, IN 46208 USA