CCAAMMEERRAASSEETTTTIINNGG
Power OnOff Camera On
Zoom Lever Wide Angle Setting
Focus Auto Mode
IINNSSTTAALLLLAATTIIOONN
CCAAMMEERRAA TTRRAAYY________________________________________________________________________________________________________________________
The camera mounts to the tray which extends from the back plate of the housing
DDOO NNOOTTremove the tray from the back plate The camera strap MUST be positioned
underneath the camera tray as noted below
Remove camera strap from front loop on the camera
Open the camera LCD screen
Place the camera against the stabilizing pins on the tray Secure camera with
the tripod mounting bolt The camera should fit easily on the tray and should
be parallel with the sides of the tray
Loop the camera strap underneath the camera tray and attach the open end
of the strap around the spring pin on the housing back
Press the LCD screen against the shade on the back
RReemmoovvee tthhee ccaammeerraa ssttrraapp ffrroomm tthhee
ffrroonntt lloooopp oonn tthhee ccaammeerraa
LLoooopp tthhee ccaammeerraa ssttrraapp
uunnddeerrnneeaatthh tthhee ccaammeerraa ttrraayy aanndd
aattttaacchh tthhee ooppeenn eenndd ooff tthhee ssttrraapp
aarroouunndd tthhee sspprriinngg ppiinn oonn tthhee
hhoouussiinngg bbaacckk wwiitthh tthhee ffllaapp ooppeenn
FFIINNAALL PPRREEPPAARRAATTIIOONN__________________________________________________________________________________________________________
Remove the lens cap lens hood and cord from the camera Otherwise they may
interfere with the housing seal
The cameras auto focus feature is utilized underwater For best results move in close to
your subject and use the wide angle range to shoot thru as little water as possible The full
zoom range is accessible underwater
Chart shows recommended initial settings underwater
IINNSSTTAALLLLAATTIIOONN ccoonnttiinnuueedd
IINNSSEERRTTIINNGG TTHHEE CCAAMMEERRAA__________________________________________________________________________________________________
Check that the clean oring is properly positioned on the lip of the clear back plate
Place the lid snaps in the open position
Once the camera is mounted to the tray and the camera strap is secured underneath
the tray pull the housing controls out to provide clearance for the camera Align the
back plate with the clear housing and slowly place the back plate against the housing
DDOO NNOOTTforce this installation; if the controls are out of the way and everything
is lined up properly the camera and tray will fit easily inside Make certain that the tray
is completely in the housing The front should be flat against the housing and NOT tilted
on one side
HHOOUUSSIINNGG CCOONNTTRROOLLSS__________________________________________________________________________________________________________
Slide the housing controls back in place making sure they properly align with the
camera functions Fasten the opposite lid snaps at the same timeDDOO NNOOTTfasten one
at a time
Operate each control to see how it works with the camera Some controls such as
startstop will be used frequently Other controls may seldom be utilized Refer to your
camera owners manual for the proper function of each camera control Look thru the
back to be sure that you can see into the viewfinder
When using the housing controls especially the startstop DDOO NNOOTTuse excessive
force because you could damage the camera
CCAAUUTTIIOONN
Remove the lens cap and cord from the camera Otherwise the cord may
interfere with the housing seal
If the housing controls are not properly positioned they could interfere with the housing seal
IIKKEELLIITTEE UUNNDDEERRWWAATTEERR SSYYSSTTEEMMSS
West rd Street • PO Box • Indianapolis IN USA •
Email: ikelite@ikelitecom • wwwikelitecom