iLive IAEB29 v2276-01 User manual

Wireless Earbuds
User’s Guide for Model IAEB29 v2276-01
Volume / Skip
Press and hold to adjust volume.
Press to skip ahead or back.
Power / Pair / Play / Pause /
Speakerphone
Press and hold to power ON or OFF.
Press and hold for 9 seconds to power
ON and pair Bluetooth.
Press to play or pause audio.
Press to answer incoming phone call.
Orientation & Controls (Right Earbud only)
Battery Charging
• Pull back the cover on the DC Power Input.
• Using a Micro-USB to USB cable, connect to
the USB port of a powered on computer or USB
power adaptor (not included).
Initial charge time is approximately 2 hours. Charge
fully before use.
When the battery is low an indicator LED will ash
red for 1 minute and a voice will announce “Low
Battery,”then the unit will automatically power OFF.
While the unit is charging it will display a solid red
light. When the unit is fully charged it will display a
solid blue light.
DC Power Input
Microphone
Indicator LED
Features
• Rubberized coating
• Sweat proof
• Bluetooth Wireless: range 33 ft.
• Active noise cancellation
• Built-in microphone
• Voice prompts announce earbud operations
• Digital volume control
• Built-in rechargeable battery: aprroximately 4
hrs playtime
• Micro-USB port for battery recharge
Includes
• 3 pairs of eartips: 1 small, 1 medium, 1 large
• Micro-USB to USB charging cable

Customer Support
Customer Service: 1-888-999-4215 | Email Support: prodinfo@
dpiinc.com | Email Parts: [email protected]
For Warranty Information and the most up-to-date version of
this User’s Guide, go to www.iLiveElectronics.com
To download this User’s Guide in English, Spanish, or French, or
to get answers to frequently asked questions, visit the support
section at: www.iLiveElectronics.com
Para descargar este Manual del Usuario en inglés, español y
francés, o para obtener respuestas a preguntas frecuentes,
visite la sección de apoyo en: www.iLiveElectronics.com
Pour télécharger ce guide de l’utilisateur en anglais, espagnol
ou français, ou pour obtenir des réponses à des questions
fréquemment posées, consultez la rubrique d’assistance sur:
www.iLiveElectronics.com
Copyright © 2019 Digital Products
International (DPI, Inc.) All other trademarks
appearing herein are the property of their
respective owners. Specications are subject
to change without notice.
FCC Warnings
WARNING: Changes or modications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Additional Warnings
• WARNING: To prevent re or shock hazards, do not expose this
unit to rain or moisture.
• WARNING : Where the mains plug or appliance coupler is used
as the disconnect device, such disconnect device shall remain
readily operable.
• Lithium batteries, like all rechargeable batteries, are recyclable
and should be recycled or disposed of according to state and local
guidelines. They should never be disposed of in normal household
waste, and they should never be incinerated, as they might
explode. Contact your local government for disposal or recycling
practices in your area.
• To avoid hearing damage, make sure that the volume on your
music player is turned down before connecting your headphones.
After placing headphones in/on your ears, gradually turn up the
volume until you reach a comfortable listening level.
Speakerphone
1. To accept a call, press the button, or use the controls
on the connected phone.
2. To end a call, press the button, or use the controls on
the connected phone.
3. To re-dial the last dialed number, press the button
twice.
WARNING: This product can expose you to chemicals
including lead, which is known to the State of California to
cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
This product meets and complies with all Federal
regulations.
Initial Bluetooth Connection
1. With the earbuds powered OFF, press and hold
until they power ON and the voice prompt
says“Power on...Bluetooth is connecting.” When
pairing, remain within 3 feet of the Bluetooth
device.
2. Using the controls on your Bluetooth device,
select IAEB29 in the Bluetooth Settings to pair.
If need be, refer to the user’s manual for your specic
device for more information.
3. When successfully paired, a voice will announce
“Bluetooth is connected” and the LED indicator
will blink twice every few seconds. Audio from
the connected Bluetooth device will now be
heard through the earbuds.
4. Use the controls on the connected Bluetooth
device to select and play audio. Use the earbud
controls or the connected Bluetooth device to
play, pause, and adjust the volume level.
5. After initial pairing, press and hold until the
voice prompt says“Power on.” The earbuds
will power ON and automatically connect to the
Bluetooth device.
Previously Connected Devices
• The earbuds can remember multiple Bluetooth
devices and will always try to re-connect to the
last device used.
• To re-connect to a dierent device, turn o
Bluetooth on unwanted devices, then access the
Bluetooth settings menu on the device you wish
to use and select IAEB29.
Troubleshooting
If the earbuds should become unpaired or will not
connect normally, follow these steps in your device’s
Bluetooth Settings Menu.
1. Delete the earbuds (“Forget This Device”).
2. Turn Bluetooth OFF then ON again, and repeat
the Initial Bluetooth Connection steps.
Made
Green