Illumitex Corona CX User manual

INSTALLATION INSTRUCTIONS
IMPORTANT: Read all instructions before performing any work. Be sure all
power is off prior to installing luminaire.
WARNING: Luminaire must be grounded in accordance with appropriate
codes. Failure to do so may result in serious injury.
Corona CX 5/14/2013
Corona Linear Flood Mounting Installation Instructions
Linear Flood Mount
© 2013 Illumitex Inc. All rights reserved. The information in this document is subject to change without prior notice.
Illumitex Inc. | 5307 Industrial Oaks Blvd., Ste. 100 | Austin, TX 78735 USA | [phone] | www.illumitex.com
½” Rigid Conduit Stem
Base
Linear Flood Mount
For installation the Corona using a Linear Flood Mount
system the following instructions should be followed by a
qualified Electrician
1. *Remove Corona light bar assembly from carton with
cable attached.
2. *Assembly the two stem mounting stand by attaching ½”
rigid conduit to base using hardware supplied.
3. *Then insert cable through conduit and thread conduit
into end cap holes. Use supplied Teflon tape.
*Instructions 1-3 are not relevant for the 6” pipe that is
included with the fixture. These instructions pertain only to
the optional 12” and 18” stanchions (available as
accessories).

INSTALLATION INSTRUCTIONS
IMPORTANT: Read all instructions before performing any work. Be sure all
power is off prior to installing luminaire.
WARNING: Luminaire must be grounded in accordance with appropriate
codes. Failure to do so may result in serious injury.
Corona CX 5/14/2013
Corona Linear Flood Mounting Installation Instructions
Linear Flood Mount
For installation the Corona using a Linear Flood Mount
system the following instructions should be followed by a
qualified Electrician
4. Next install 4” round junction box to a preformed
concrete base using concrete fasteners (supplied by
others).
5. Feed wires through gasket and attach to base.
Concrete Fasteners &
Junction Box
(Supplied By Others)
© 2013 Illumitex Inc. All rights reserved. The information in this document is subject to change without prior notice.
Illumitex Inc. | 5307 Industrial Oaks Blvd., Ste. 100 | Austin, TX 78735 USA | [phone] | www.illumitex.com
½”Rigid Conduit Stem
6. Wire the input wires to the line voltage wires coming.
Follow the standard color wire scheme. Gel filled wire
nuts are recommended .
7. Mount Corona’s base to the 4” round junction box using
the screws provided to base, feed wires. Tighten screws
to 12 ft/lbs.
8. Loosen hex end bolt and adjust the angle.
9. Power ON the Corona and ensure that all LEDs light.
Black = 120-277 VAC
White = eutral/Common
Green = Ground
Fasteners
Gasket