ILVE OV60SNT3-BRZ User guide

BUILT-IN
ELECTRIC OVENS
USER – Use and Maintenance
INSTALLER – Installation and maintenance
cod. EI33960070000EN
36/2020
ZONA PER TARGHETTA
EN

4 IMPORTANT SAFETY WARNINGS
4 Appliances’ data
8 First start-up
9 ISTRUZIONI PER L’USO
9 MP models
11 MP models with 5 key programmer
13 E3 models with 5 key programmer
18 TFT touch display
21 T3 static model with TFT touch
23 Accessories
24 CLEANING AND MAINTENANCE
24 Oven cleaning and care
25 Oven door disassembly
26 Recommendations for cleaning the oven and the
front panel
27 Lamp replacement
28 PROBLEM SOLVING
28 Guide for the resolution
28 Children Lock
29 TFT display errors
30 COOKING CHART
30 Fan oven cooking chart
31 Natural convection oven cooking chart
32 Inside food temperature (°C)
33 INSTALLATION
33 Instructions for installation
34 Electrical connection
34 Installation rules
35 Wiring diagrams
INDEX

4
IMPORTANT
SAFETY WARNINGS
Appliances’
data
CAUTION
1
2
3
4
As well as being shown on the cover, the data plate
is applied to the oven door frame and is visible with
the door open.
These warnings refer to different types of appliance.
Pay attention in properly identifying the type you own
(see the data plate).
These warnings are valid for the countries
mentioned in the plate.
Before using the cooker, read the instructions booklet
carefully.
This contains very important information concerning
safety during installation, use and maintenance.
The instructions booklet must be kept with care for
later consultation.
The electrical safety of this cooker is guaranteed only
if it is correctly grounded as required by the regula-
tions.
It is fundamental to ensure that these regulations
have been respected; if you are in doubt, contact a
skilled technician to have the electric system accura-
tely checked.
The manufacturer is not responsible for damage
caused by a bad grounding system.
Before powering the appliance, check that the te-
chnical features shown on the data plate match
those of the electrical system perfectly.
Installation/regulation must be carried out by qua-
lied personnel.
Check that the electrical system and the sockets
have the capacity to withstand the maximum power
of the appliance which is shown on the plate.
If in doubt, contact a qualied person.

5
USER
IMPORTANT
SAFETY WARNINGS
The device must be connected directly to the power
supply with the correct polarity.
The connection must have a device ensuring discon-
nection from the network, with an opening distance
of the contacts that allows complete disconnection
in the conditions of overvoltage category III, in accor-
dance with installation instructions.
If the socket is not suitable for the plug, replace it with
a suitable one and in this case contact a qualied
person who will also check if the cable section of
the socket can withstand the power consumed by
the appliance. The power cable does not have a t-
ted plug. For connection see “Electrical connection”
section. The use of adapters, multiple sockets or ex-
tension leads, is not recommended.
When the appliance is not used for a long time, re-
move the electrical connection and disconnect the
mains switch.
Do not block ventilation or heat dissipation slots.
If the appliance’s electrical power cable is damaged,
it must only be replaced by a manufacturer appro-
ved service centre.
The appliance must only be used for the purposes it
is intended for (cooking).Any other use (e.g. heating
a room) is improper and dangerous.
The manufacturer declines any responsibility for da-
mages caused by such improper uses.
5
6
7
8
9
10