IMAGIMAGS MARBLE RUN SET User manual

MARBLE RUN SET
INSPIRATION & USER MANUAL

WHAT’S IN THE SET

CONNECTOR SQUARE
Clip the chutes, straights, bends and cups onto the
connector squares.
Use the connector squares to build the foundation of
your marble run.

CORNER CHUTE
Clip each side of the corner chute onto the connector
square to create a 90°angle.
Use the red corner chutes to quickly change the
direction of your marbles transversing through
your run!

SLOPE
Clip one side of the slope onto a connector square and
the other side onto another connector square, it will be
spaced one square below.
Use the pink slopes to add momentum and gain speed!

SHORT STRAIGHT
Clip each side of the short straight onto a square
connector.
The short straight can be used both vertically and
horizontally!

Lay two connector tiles corner to corner, diagonally
opposite one another. Clip one side of the diagonal
chute onto a connector and connect the other side
onto the diagonally opposite connector.
DIAGONAL CHUTE
Use the diagonal chute to change direction and gain
speed. If there is a small gap between the tubes don’t
worry, it won’t change the speed of your runs!

HAIRPIN BEND
Clip each side of the hairpin bend onto a square
connector.
The hairpin bend can be used both vertically and
horizontally, which allows you to change the direction
of your transversing marbles!

LONG STRAIGHT
Clip each side of the long straight onto a square
connector.
The long straight can be used both vertically and
horizontally. Use the straight vertically to add speed,
and horizontally to slow your marbles down!

CUP
Clip a square connector onto the opening and / or the
circular base of the cup.
Use the cups at the start and end of your runs to
create a ‘whirl pool’ effect with your marbles!