Impact Acoustics Tensed Division Helios User manual

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 210802
1/3
HELIOS
Acoustic Room Divider
technical changes, errors and colour variations are reserved
assembly instructions

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 210802
2/3
Helios
C
D
A
B
technical changes, errors and colour variations are reserved
assembly instructions
1.
Screw the set screws (B) into the grippers (A).
After that, the gripper can be turned into the
square tube.
2.
Screw the square tubes to the ceiling and to the
floor. Do not tighten the screws completely, the
square tubes should still have about 8mm of play.
These screws are not supplied. The holes on
the wall side have a diameter of 9 mm and
the other holes have a diameter of 15.5mm.
3.
Insert the wire ropes (C) into the grippers on the
ceiling. Then those on the floor can be inserted
and tightened. The ends can be guided into holes
provided. Now the screws are tightened and the
wire ropes get enough tension. Insert the cover
caps (D).
Make sure that the two holes
are aligned as shown.

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 210802
3/3
Helios
E
F
technical changes, errors and colour variations are reserved
assembly instructions
4.
Screw the base plates (E) to the panels,
the positions are marked. Make sure that
the screws are tightened only slightly.
5.
Now the magnets (F) are screwed onto
the other half of the panels. Make sure
that the screws are tightened only slightly.
Now the circles with the magnets can be
attached to the already mounted circles.