Imperial Radcliffe Westbury Twin Vanity Unit with 3... User manual

INSTRUCT183
REV060717 A JRS
Installation instructions for Radcliffe Westbury Twin Vanity Unit
with 3 Drawers
Important Information:
Please check the products for transport damage and that contents are complete
before installation.
Consult a qualified plumber if you have any problems installing this product.
Complaints made following installation regarding the above cannot be accepted.

2 of 8
Thank you for purchasing this Imperial product. Please take a moment to
review this manual before you install your product. If you encounter any
installation or performance problems, please do not hesitate to contact us
using the phone number listed on the back cover of the booklet.
Upon receiving your product please open all cartons carefully and inspect for
any manufacturing defects or transit damage.
Imperial cannot be held responsible for damaged products after or during
their installation.
Ensure that you have a clear space within which to work.
Imperial recommend the guidance of a qualified plumber in the
installation process.
Always observe the plumbing and building regulations in the area the
product is being installed in.
General Instructions
Tools Required
drill screwdriver spirit level pencil spanner silicon
Westbury Twin Vanity Unit
with 3 Drawers

3 of 8
Prior to drilling check for hidden cables & pipes
• Prior to installation ensure all necessary pipework and plumbing is carried out.
• Check wall for level.
Waste (Wall) Outlet Position
back
board
back
board
underside of
slate 335mm
top of board
380
375
60
40
Standard
Waste
Pop-Up
Waste
Trad Bottle Modern Bottle P Trap S Trap
(430) 55mm min
(396) 21mm max
(418) 43mm min
(396) 21mm max
(419) 44mm min
(396) 21mm max
(407) 32mm min
(396) 21mm max
(446) 71mm min
(396) 21mm max
(430) 55mm min
(396) 21mm max
N/A
N/A
(max) = top of backboard (375mm) + (pipe clearance + 1/2 waste diameter)

4 of 8
Technical specification
1240
845
600
280
1200
815
585
30
1240
340
200
30
600
620
60
1200
82 41
20

5 of 8
Care & Maintenance
You have just acquired a high quality and expensive piece of furniture and are about
to put it in the most hostile environment in the house! We have been producing
these fine products for many years and our experience is that they will give years of
pleasurable service if a few simple measures are taken to look after them.
Ceramic:
The glazed finish of your sanitaryware should be cleaned after use by applying
a little cream type cleaner. Apply using a sponge or damp cloth and rinse
thoroughly with clean water. Cleaners containing abrasive materials
should be avoided.
Metal:
Parts with Chrome/Gold finish should be cleaned with a damp soft cloth only.
The use of detergents and abrasive cleaning agents should be avoided as these
will cause damage to the finish of the metal.
Care and cleaning of Imperial products
To preserve the finish of Gold and Nickel plated items Imperial recommend the use
of soap and water only for cleaning and ensure that the product is thoroughly dried
after with a soft lint free cloth. Do not use abrasive polish or cleaners.
Commercial/domestic spray cleaners are not to be used as they contain strong chemicals
that will burn and even remove the plated finish.
In the event of strong bleaches or cleaning products being used resulting in plated
finish being chemically burnt/tarnished will be void any warranty or guarantee.
Care should be taken with hand gels and mouth wash as they contain alcohol which
will burn and tarnish the plated finish.
In the event of spillage as listed above revert to the cleaning instruction above.

6 of 8
Wood:
Bathroom furniture can be wiped over using a damp cloth and dried with a soft
duster. The use of polishes using silicon or any abrasive materials can damage
the wood finish. Natural wax polishes should be used sparingly and applied
using a soft dry cloth.
Always use your best efforts to keep the wood surface dry. The finish will
deteriorate and the underlying timber could become permanently stained if
subjected to long term contact with water.
Dark and light oak oiled finishes
Units and cabinets are manufactured from solid wood and have been crafted
and finished by hand within Imperial’s factory.
The finish is applied by hand onto solid wood to maintain the natural look of
the grain. The surface is not finished with a clear lacquer.
Like all hand made quality furniture within the home, care needs to be taken
against spillage otherwise the finish could become compromised resulting in
permanent staining of the wood surface.
Spillages should be wiped dry imediately after use with a soft lint free cloth. In
the event of staining or damage a care kit or recovery kit is required.

The Imperial Bathroom Company
England
Tel: [phone], Fax: [phone]
www.imperial-bathrooms.co.uk