Impex MARCY SB-241 User manual

NOTE:
Please read all instructions
carefully before using this
product
Table of Content
Safety Notice
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
SB-241
Retain This
Manual for
Reference
06-19-09
OWNER'S
MANUAL
MARCY®Multi Purpose Bench
SB-241
IMPEX®Inc.
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: [phone] Fax: [phone]
www.impex-fitness.com
[email protected]

TABLE OF CONTENTS
BEFORE YOU BEGIN...................................................................................... 1
IMPORTANT SAFETY NOTICES..................................................................... 2
HARDWARE IDENTIFIER.....…....................................................................... 4
ASSEMBLY INSTRUCTIONS........................................................................... 6
EXPLODED DIAGRAM……………………………………………………………… 9
PARTS LIST...................................................................................................... 10
WARRANTY.................................................................................................…. 11
ORDERING PARTS.......................................................................................… 11
BEFORE YOU BEGIN
Thank you for selecting the MARCY SB-241 Multi Purpose Bench by IMPEX®
Inc. For your safety and benefit, read this manual carefully before using the
machine. As the manufacturer, we are committed to provide you complete
customer satisfaction. If you have any questions, or find there are missing or
damaged parts, we guarantee you complete satisfaction through direct
assistance from our factory. To avoid unnecessary delays, please call our
TOLL-FREE customer service number. Our Customer Service Agents will
provide immediate assistance to you.
1
11
1
Toll-Free Customer Service Number
1-800-999-8899
Mon. - Fri. 9 a.m. - 5 p.m. PST
www.impex-fitness.com
[email protected]m

IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire manual
before you assemble or operate your machine. In particular, note the following safety
precautions:
1. Keep children and pets away from the machine at all times. DO NOT
leave children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. DO NOT place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
12.This machine is designed and intended for home and consumer use only, not for
commercial use.
13. Maximum user weight: 300 lbs.
14. Assembled Dimension: 57” x 25” x 46”
CARE AND MAINTENANCE
1. Inspect and tighten all parts before using the machine.
2. Immediately replace worn or damaged parts obtained from the manufacturer.
3. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
4. Keep fingers away from all Pinch Points.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE
AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.
ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY
DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2

WARNING LABEL PLACEMENT
The Warning Label shown here has been placed on the Rear Stabilizer.
If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement.
Apply the label in the location shown.
3

HARDWARE PACK
NOTE: The following parts are not drawn to scale. Please use your own ruler to measure the size.

4
HARDWARE PACK
NOTE: The following parts are not drawn to scale. Please use your own ruler to measure the size.

5
ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen Wrench

NOTE: It is strongly recommended that two or more people assemble this machine to
avoid possible injuries.
STEP 1 (See Diagram 1)
A.) Do not tighten all Nuts and Bolts until instructed to do so.
B.) Attach the Front Vertical Frame (#4) to the Front Stabilizer (#2). Secure it with two M10 x 2
3/8” Carriage Bolts (#25), one Bracket (#12), two Ø ¾” Washers (#34), and two M10 Aircraft
Nuts (#36).
C.) Attach the Main Frame (#1) to Front Vertical Frame. Secure the lower hole with one M10 x 3
3/8” Allen Bolt (#27), two Ø ¾” Washers (#34), and one M10 Aircraft Nut (#36). Secure the
upper hole with a L-shaped Lock Pin (#22). Pull out the Lock Pin enable to fold the Front
Vertical Frame.
D.) Attach the Main Frame to the Rear Stabilizer (#3). Secure it with two M10 x 3” Allen Bolts
(#29), four Ø ¾” Washers (#34), and two M10 Aircraft Nuts (#36).
E.) Attach the two L-shaped Seat Brackets (#11) to the Main Frame from both sides. Secure them
together with one M10 x 3 1/8” Allen Bolt (#28), two Ø ¾” Washers (#34), and one M10
Aircraft Nut (#36).
F.) Securely tighten all Nuts and Bolts installed in the Step. DIAGRAM 1
6
STEP 2 (See Diagram 2)

A.) Attach the pivot on Incline Support (#5) in between the two Backrest Supports (#6).
Attach the other end of Incline Support to the selected open slot on Main Frame (#1) to
hold the selected incline in position.
B.) Attach the side-holes of the two Backrest Supports (#6) to the Pivot on the Main Frame
(#3). Secure them with one M12 x 5 ¼” Hex Bolt (#24), two Ø 1” Washer (#33), and one
M12 Aircraft Nut (#37).
DIAGRAM 2
7

STEP 3 (See Diagram3)
A.) Place the Seat pad (#10) onto Main Frame (#1). Secure it to the two L-shaped Brackets (#11)
with two M8 x ¾” Allen Bolts (#32) and two Ø 5/8” Washers (#35). Secure the Seat to the Main
Frame with one M8 x 2 1/8” Allen Bolt (#30) and one Ø 5/8” Washer (#35).
B.) Attach the Backrest Board (#9) to the two Backrest Supports (#6). Secure it with four M8 x 1
5/8” Allen Bolts (#31) and four Ø 5/8” Washers (#35).
C.) Insert the Foam Tube (#8) halfway through the hole on the Front Vertical Frame (#4). Push
two Ø 2 ¾” Foam Rolls (#14) onto the Tubes.
D.) Insert the Long Foam Tube (#7) halfway through the upper hole on Front Vertical Frame. Push
two Ø 3 1/8” Foam Rolls (#13) onto the Long Tube. Lubricate the inside of the Foam Grips
(#15) with water. Slide the Foam Grips onto the Long Foam Tube (#7) from both sides.
DIAGRAM 3
8

9

Parts list
KEY NO. DESCRIPTION Q’ty
1 Main Frame 1
2 Front Stabilizer 1
3 Rear Stabilizer 1
4 Front Vertical Frame 1
5 Incline Support 1
6 Backrest Support 2
7 Long Foam Tube 1
8 Foam Tube 1
9 Backrest Board 1
10 Seat Pad 1
11 L-shaped Seat Bracket 2
12 Bracket 1
13 Ø 3 1/8” Foam Roll 2
14 Ø 2 ¾” Foam Roll 2
15 Foam Grip 2
16 1” Square End Cap 2
17 Ø 1” End Cap 4
18 1 5/8” x 2 3/8” End Cap 1
19 Ø 2 3/8” End Cap 4
20 Ø 3 ½” Stabilizer End Cap 4
21 Rubber Bumper 1
22 L-shaped Lock Pin 1
23 M6 x 5/8” Philips Screw 1
24 M12 x 5 ¼” Hex Bolt 1
25 M10 x 2 3/8” Carriage Bolt 2
26 M10 x 5 ¼” Allen Bolt 1
27 M10 x 3 3/8” Allen Bolt 1
28 M10 x 3 1/8” Allen Bolt 1
29 M10 x 3” Allen Bolt 2
30 M8 x 2 1/8” Allen Bolt 1
31 M8 x 1 5/8” Allen Bolt 4
32 M8 x ¾” Allen Bolt 2
33 Ø 1” Washer 2
34 Ø ¾” Washer 12
35 Ø 5/8” Washer 7
36 M10 Aircraft Nut 7
37 M12 Aircraft Nut 1
#5 Allen Wrench (Tool) 1
#6 Allen Wrench (Tool) 1
10

IMPEX®INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and
material, under normal use and service conditions, for a period of two years on the Frame from
the date of purchase. This warranty extends only to the original purchaser. IMPEX's obligation
under this Warranty is limited to replacing or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling
IMPEX Customer Service Department at 1-800-999-8899. All freights on products returned to
IMPEX must be prepaid by the customer. This warranty does not extend to any product or
damage to a product caused by or attributable to freight damage, abuse, misuse, improper or
abnormal usage or repairs not provided by an IMPEX authorized service center or for products
used for commercial or rental purposes. No other warranty beyond that specifically set forth
above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or
in connection with the use or performance of the product or other damages with respect to any
economic loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of
removal, installation or other consequential damages or whatsoever natures. Some states do not
allow the exclusion or limitation of incidental or consequential damages. Accordingly, the above
limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied
warranties of merchantability or fitness for a particular purpose is limited in its scope and duration
to the terms set forth herein. Some states do not allow limitations on how long an implied
warranty lasts. Accordingly, the above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state
to state.
IMPEX®INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-
999-8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific
standard time.
www.impex-fitness.com
[e-mail]
When ordering replacement parts, always give the following information.
1. Model
2. Description of Parts
3. Part Number
4. Date of Purchase
11