Impex POWERHOUSE SR55 User manual

NOTE:
Please read all instructions
carefully before using this
product
Safety Notice
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
SR55
Retain This
Manual for
Reference
08-07-01
OWNER'S
MANUAL
POWERHOUSE
SQUAT RACK SR55
IMPEX FITNESS PRODUCTS
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: [phone] Fax: [phone]
www.impex-fitness.com
[email protected]

TABLE OF CONTENTS
BEFORE YOU BEGIN...................................................................................... 1
IMPORTANT SAFETY NOTICES..................................................................... 2
HARDWARE IDENTIFIER.....…....................................................................... 3
ASSEMBLY INSTRUCTIONS........................................................................... 4
EXPLODED DIAGRAM……………………………………………………………... 5
PARTS LIST……………………………………………………………………….. 6
WARRANTY.................................................................................................… 7
ORDERING PARTS......................................................................................... 7
BEFORE YOU BEGIN
Thank you for selecting the POWERHOUSE SQUAT RACK SR55 by IMPEX
FITNESS PRODUCTS. For your safety and benefit, read this manual carefully
before using the machine. As a manufacturer, we are committed to provide
you complete customer satisfaction. If you have any questions, or find there
are missing or damaged parts, we guarantee you complete satisfaction
through direct assistance from our factory. To avoid unnecessary delays,
please call our TOLL-FREE customer service number. Our Customer Service
Agents will provide immediate assistance to you.
1
Toll-Free Customer Service Number
1-800-999-8899
Mon. - Fri. 9 a.m. - 5 p.m. PST
www.impex-fitness.com
[email protected]m

IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire manual
before you assemble or operate your machine. In particular, note the following safety
precautions:
1. Keep children and pets away from the machine at all times. DO NOT
leave children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN
IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE
OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.
ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY
DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2

3

ASSEMBLY INSTRUCTION
Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended this machine to be assembled by two or more
people to avoid possible injury.
STEP 1 (See Exploded Diagram)
A.) Attach a base Frame (#19) to the end of Main Base Frame (#4). Secure it with one
Bracket (#18), two M10 x 2 ¾” Carriage Bolts (#6), two ∅¾” Washers (#9), and M10
Aircraft Nuts (#23). Repeat the same procedure to connect the other Base Frame
(#19) on the other side.
B.) Attach the Left Rear Vertical Frame (#12) to the Base Frame (#19). Align the holes to
the Bracket (#18). Secure it with two M10 x 2 ¾” Carriage Bolts (#6), ∅¾” Washers
(#9), and M10 Aircraft Nuts (#23). Repeat the same procedure to install the other
side.
C.) Attach the Front Vertical Frame (#25) to the Base Frame (#19). Secure it with three
M10 x 5/8” Allen Bolts (#8) and ∅¾” Washers (#9). Secure the Front Vertical Frame
(#25) to the Left Rear Vertical Frame (#12) with two M10 x 5/8” Allen Bolts (#8) and
∅¾” Washers (#9). Repeat the same procedure to install the other side.
D.) Attach one Diagonal Support (#5) to the Main Base Frame (#4). Attach the other end
to the Rear Vertical Frame (#12). Secure the top and the bottom of the Diagonal
Support (#5) with two M10 x 2 ¾” Carriage Bolts (#6), ∅¾” Washers (#9), and M10
Aircraft Nuts (#23). Repeat the same procedure to install the other side.
E.) Insert two Weight Holders (#13) into the two holes on the Rear Vertical Frame (#12).
Secure each Weight Holder with one M10 x 1” Allen Bolt (#24) and ∅¾” Washer
(#9). Slide two Olympic Sleeves (#14) onto the Holders. Secure each Sleeve with a
M8 x ½” Allen Set Screw (#16). Repeat the same procedure to install the other side.
F.) Insert the Right & Left Bar Catches (#1) & (#20) into the selected holes on the Front
Vertical Frames (#25).
4


5

PARTS LIST
KEY NO. DESCRIPTION Q’ty
1 Right Bar Catch 1
2 ∅1” Bar Catch End Cap 2
3 Right Rear Vertical Frame 1
4 Main Base Frame 1
5 Diagonal Support 2
6 M10 x 2 ¾” Carriage Bolt 12
7 Panel 2
8 M10 x 5/8” Allen Bolt 10
9 ∅¾” Washer 26
10 M5 x 3/8” Philips Screw 6
11 2” x 2 ¾” End Cap 2
12 Left Rear Vertical Frame 1
13 Weight Holder 4
14 Olympic Sleeve 4
15 ∅2” End Cap 4
16 M8 x ½” Allen Set Screw 4
17 2” Square End Cap 4
18 Bracket 2
19 Base Frame 2
20 Left Bar Catch 1
21 2” Flat End Cap 2
22 Rubber Pad 2
23 M10 Aircraft Nut 12
24 M10 x 1” Allen Bolt 4
25 Front Vertical Frame 2
6

IMPEX INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under normal
use and service conditions, for a period of two years on the Frame from the date of purchase. This warranty
extends only to the original purchaser. IMPEX's obligation under this Warranty is limited to replacing or
repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX Customer
Service Department at 1-800-999-8899. All freights on products returned to IMPEX must be prepaid by the
customer. This warranty does not extend to any product or damage to a product caused by or attributable to
freight damage, abuse, misuse, improper or abnormal usage or repairs not provided by an IMPEX authorized
service center or for products used for commercial or rental purposes. No other warranty beyond that
specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in connection
with the use or performance of the product or other damages with respect to any economic loss, loss of
property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation or other
consequential damages or whatsoever natures. Some states do not allow the exclusion or limitation of
incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the above
limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to state.
Register on-line at www.impex-fitness.com
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-8899
during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
[e-mail]
When ordering replacement parts, always give the following information.
1. Model
2. Description of Parts
3. Part Number
4. Date of Purchase
7