In The Ditch ITD1260 User manual

Parts List:
Item # Qty Description Part #
1 (1) Chock Assembly - Includes chock, chock axle, linch clip,
threaded knob ITD6242
2 (1) Tube Assembly ITD6241
3 (1) Main Body Assembly - Includes body weldment, roller,
wheels, tire guide ITD6244
4 (1) Tire Roller ITD7101
5 (1) Thread Knob ITD7050
6 (1) Replacement Tire Kit ITD6243
For missing or damaged parts, please call 1-888-993-4824
www.INTHEDITCH.com
ASSEMBLY INSTRUCTIONS
READ ALL SAFETY WARNINGS & INSTRUCTIONS CAREFULLY
BEFORE USING THE TRAVELING SPEED CHOCK.
Assembly/Operations of Traveling Speed Chock
ITD1260
Below is a list of parts needed to assembly a Traveling Speed Chock.
Hardware is included with product
Required Hardware List For Assembly:
(3) 1/4” x 3/4” Carriage Bolt
(3) 1/4” Washers
(3) 1/4” Nylok Nuts
ITD0138R2
(1) Knob
(1) Push Cap
(1) Linch Clip

Operation:
WARNING
This device is intended to help control a runaway vehicle during an unexpected wire rope disconnect from
loading or unloading a vehicle from a carrier deck.
Due to varying conditions there is no guarantee the vehicle will be stopped on the deck. The device is only
designed to help slow the descent.
Traveling Speed Chock is NOT designed as a stop, never place any body part behind the wheel during op-
eration.
Chock works with most vehicles.
Assembly Procedure:
Traveling Speed Chock is reversible and can be assembled to be used on the Driver’s or Passenger’s side.
Diagrams below represent product being assembled for the
Driver’s side.
DRIVER’S SIDE CONFIGURATION
One Side Only,
Opposite of Main Tube