Indesit IDC 75 User manual

EN
1
English,1
Contents
Important information, 2-3
Installation, 4
Where to install the tumble dryer
Ventilation
Electrical connections
Preliminary information
Description of the tumble dryer,
Features
Control panel
How to carry out a drying cycle, 6
Starting a drying programme
Drying settings, 7
Drying times
Drying programmes and options
Laundry, 8
Sorting laundry
Care labels
Special items
Warnings and suggestions, 9
General safety
Information on recycling and disposal
Saving energy and respecting the environment
Care and maintenance, 10
Disconnecting the power supply
Cleaning the filter after each cycle
Chec ing the drum after each cycle
Emptying the water container after each cycle
Cleaning the condenser unit
Cleaning the tumble dryer
Troubleshooting, 11
Assistance, 12
Spare parts
EN
IDC 7
 Keep this manual at hand for immediate reference
whenever necessary. Always store this manual close to the
tumble dryer and remember to pass it on to any new owners
when selling or transferring the appliance, so they may
familiarise with the warnings and suggestions herein
contained.
 Read these instructions carefully: the following pages
contain important information on installation and useful
suggestions for operating the appliance.
Instruction manual
TUMBLE DRYER
Nederlands,49
I
Français,2
F
Deutsch,37
DE
Italiano,13
NL
Español,61
ES
Português,73
PT
All manuals and user guides at all-guides.com
all-guides.com

2
EN
2
Important information
To ensure that the condenser dryer functions
efficiently, the following routine maintenance
procedures must be carried out:
Fluff filter  CLEAN off any fluff build-up on the
filter after each drying cycle.
Step 1
Open the dryer door by pressing
it as shown in the picture.
Step 2
Pull out the filter (using two
fingers).
Step 3
Clean off any fluff build-up on the
internal surface of the filter net.
Step 4
Replace the filter  never operate
the dryer without the filter in
place.
Failure to clean the filter after each drying cycle
will reduce drying performance. The machine will
take longer to dry and it will consume more
energy.
Water container  empty the water container after
each drying cycle.
Step 1
Pull the water container towards
you and remove it completely
from the dryer.
Step 2
Empty all the water in the water
container.
Step 3
Replace the water container
ma ing sure that it is securely
fixed.
Failure to empty the water container may cause
the following:
- The dryer stops heating (thus the load may still
be damp at the end of the drying cycle).
- The Empty water container light lights up to
signal that the water container is full.
Filling of the Water Container
When the dryer is first used water will not
immediately enter the water container as the
pump needs to be primed. This is done
automatically and will take a few minutes, during
this period the efficiency of the drying process is
not affected.
All manuals and user guides at all-guides.com

EN
3
Condenser unit - remove any fluff build-up
from the condenser on a monthly basis.
Step 1
Open the condenser cover
- grip the handle and pull
towards you.
Step 2
Remove the condenser by
turning the 3 catches, then pull
the condenser towards you. (It is
normal for some residual water
to be left in the tubes).
Step 3
Clean the condenser with running
water over the rear side to
remove any fluff deposits.
Step 4
Replace the condenser unit;
ma e sure that the unit is
securely in place, that all 3
catches are fixed and that the
position arrows on the front end
of the condenser are pointing
upwards.
Failure to clean the condenser unit may cause
premature faults to the dryer.
All manuals and user guides at all-guides.com

4
EN
Where to install the tumble dryer
 Install the dryer far from gas
ranges, stoves, radiators or
hobs, as flames may damage it.
If the dryer is installed below a
wor top, ensure there are 10
mm between the upper panel of
the dryer and any objects
above it, and 15 mm between
the sides of the machine and
the walls or furniture units
adjacent to it. This ensures
adequate air circulation.
Ventilation
 The room must be adequately ventilated while the dryer is
running. Ma e sure that the dryer is installed in a room free of
humidity and with adequate air circulation. The flow of air
around the dryer is essential to allow water to condense
during drying; the dryer will not function properly if it is placed
in an enclosed space or inside a cabinet.
 Some condensation may form if the dryer is used in a small
or cold room.
 We do not recommend that the dryer is installed in a
cupboard but the dryer must never be installed behind a
loc able door, a sliding door or a door with a hinge on the
opposite side to that of the dryer door.
Water drain
If your dryer is installed next to a drain the water can be
plumbed into this drain. This does away with the need to
empty the water container. If the dryer is stac ed onto or
installed next to a washing machine it can share the same
drain. The height of the drain must be less than 3' (1 m)
from the bottom of the dryer.
Remove existing hose from position shown in picture A
and fit a suitable length of hose and connect as shown
in picture B.
 Make sure that the hose is not squashed or kinked
when the dryer is in its final location.
1
0
m
m
15 mm
15 mm
15 mm
15 mm
1
2
2
1
Less than 1m
Picture APicture B
Installation
Electrical connections
Before plugging the appliance into the soc et, chec the
following:
 Ma e sure your hands are dry.
 The soc et must have an earth connection.
 The soc et must be able to withstand the machines
maximum power output as indicated on the data plate (see
Description of the tumble dryer).
 The power supply voltage must fall within the values
indicated on the data plate (see Description of the tumble
dryer).
 The soc et must be compatible with the machines plug. If
not, either the soc et or the plug must be replaced.
 Do not use extension cords.
 The tumble dryer must not be installed in outdoor spaces,
even if sheltered. It may be very dangerous to expose this
appliance to rain and thunderstorms.
 Once dryer installation is complete, the electric cord and
plug must be at hand.
 The electric cord must not be bent or crushed.
 If the plug to be replaced is of the moulded-on type, it
must be disposed of in a safe way. DO NOT leave it where it
can be plugged into a soc et and cause electric shoc s.{}
 The electric cord must be regularly chec ed and replaced
with a cord specifically designed for this dryer; it must then
be installed by an authorised technician only (see
Assistance). New or longer electric cords are supplied by
authorised dealers at a supplementary cost.
 The manufacturer declines all responsibility for failure
to observe these instructions.
 When in doubt about the above indications, contact a
qualified electrician.
Preliminary information
Once the tumble dryer is installed, clean the inside of the
drum before operating it and remove any dirt accumulated
during transportation.
All manuals and user guides at all-guides.com

EN
Start
button
ress the
door
Condenser
unit (cover
open)
Water container Rating plate
Condenser cover
handle (pull to
open)
Filter
Air
intake
grille
Description of
the tumble dryer
Opening the door
Control panel
Features
Model &
Serial
Numbers
Drying time
selector nob Empty water
container
indicator light
High Heat
button
Drying time selector nob
This is used to set the drying time: turn the nob in a cloc wise direction until the indicator is set to the desired drying time (see
Drying settings). Do not attempt to turn the nob anticloc wise.
High Heat button
It can be used to customise the selected programme in accordance with your own requirements.
START button
Press the button to begin drying.
Empty water container indicator light
The Empty water container indicator light signals that the water container must be emptied.
If the container becomes full during the programme, the tumble dryer will automatically start the cold air cycle.
In order to avoid this procedure, always empty the water container after using the tumble dryer (see Care and maintenance).
All manuals and user guides at all-guides.com