Infinity ISR-Pro User manual

Top
Half
Boom
Half
Fan
Assembly
Power
Buon
Low Baery
Indicator
Main Power
Switch
Power Adapter
Port
Step 2
Charge the ISR-PRO: Plug the Wall
Adapter into the Power Adapter Port and into a
standard wall outlet.
Unit takes 6 hours to fully charge. While charg-
ing, the Low Baery Indicator will slow ash.
You can sll use the unit while it is charging!
Turn on Main Power Switch:
Turn on to enable the front
Power Buon. Turn o when
you travel with the unit to
disable the front Power
Buon.
Step 1 ON
ISR-PRO Quick Start Guide
5 Steps to Healthier Living
Step 3
Add Salt: Grasp the boom half and pull o the
top half. They are held together with magnets!
Pour a 6 gram pack of salt into the grinding barrel.
To re-assemble the unit, line up the stainless steel
front panels and replace the top half.
Pour 1 packet of salt in here
Boom View
Step 4
Press the front power buon and enjoy healthier living!
The unit is programmed to run for 5 minutes.

ISR-PRO Quick Start Guide
5 Steps to Healthier Living
For more informaon and to order more salt, please visit our website at
www.innitysaltair.com
Step 5: Cleaning Your ISR-PRO
Twist Fan Assembly to align the
dot with the unlock icon, then pull
to remove the fan assembly.
Reverse procedure to re-assemble.
1. Turn o Main Power Switch on boom and unplug
the unit from the power adapter.
2. Pull the top half from the boom half.
3. Empty the grinding barrel. Use the supplied brush to
remove all salt remnants.
4. Remove the fan assembly.
5. Clean Middle Secon (see below).
6. Clean Fan Assembly (see below).
7. Re-assemble the ISR-PRO and it is ready to go!
Microscopic parcles of salt can cover the electrical connecons and cause the unit not to work. When this occurs, it is possible
that the salt grinder will not react to the buon push. If the unit is plugged in, the boom power buon is ON, the fan assembly is
correctly locked, and the unit will not work, please try to clean the unit thoroughly, including the brass contacts, with these simple
instrucons.
Cleaning the Fan Assembly: Remove as much salt residue as possible with the supplied brush. This
includes removing salt from around the spring loaded contacts on the assembly and on and around the
fan blades.
Special Note: Your salt grinder is NOT waterproof. In fact, humidity is halotherapy’s worst enemy. Do not aempt to use
water to remove salt or clean the unit. You should also run it in an environment where the humidity is less than 50%RH for
the smallest, most benecial salt parcle size for your health.
Washing or rinsing in water will void the warranty.
Cleaning the Middle Secon: Remove as much salt residue as possible with the supplied
brush. This includes removing salt from around the spring loaded contacts on the middle
secon and in and around vortex tube. A rm toothbrush or brass brush can help!
Clean the at contacts, too. If
they are corroded, use a rm
brush.
Helpful Hint: Check that all 4 spring loaded contacts push in and release freely!