infobit iTrans DX-T-22 User manual

iTrans DX-T-22
Quick Guide
1. Product Introduction
This product is applied to the audio system field to convert
the analog audio signal to Dante audio signal. Power
supply Ethernet (PoE) switch.
2. Product Feature
1. Function Introduction: Convert the received analog
audio signals to Dante network audio signals.
2. Input & Output : Support two analog audio signal
inputs, two Dante outputs.
3. Hardware interface type: Two XLR are used to input
analog audio signals; One RJ45 port is used to output
Dante network audio signal.
4. Technical Parameters
Model No.
iTrans DX-T-22
Product Type
Audio signal adapter
Function
Convert analog audio signal to
Dante network audio signal
output
3 pin XLR F/M
2
RJ45 Port
1
Analog audio interface
XLR
Dante
RJ45
Frequency response
20Hz to 20kHz (-/+0.5dB)
Maximum signal level
(balanced)
+18dBu / +4dBu / 0dBu
Dynamic range
> 100dB
SNR (Signal to Noise Ratio)
> 100dB
THD (Total Harmonic Distortion)
< 0.01%（+4dBu）
Power consumption
<1W
Operating temperature
0-40℃
Size (LxWxH)
652mm x 32mm x 22mm
Weight
0.2kg
4. Product Overview
5. Product Connect
1. Download and install the Dante Controller from
Audinate website (www.audinate.com ).
2. Connect the device to the switch using Dante network
audio system with network cable.
3. The analog audio transmission device is connected
through the XLR interface.
4. Search for devices in Dante Controller software, Select
and open the devices to be configured. On the Routing
page, match the input row with the output column with
a custom check.
5. Once set up and configured the audio routing between
audio device, the audio device will remember and save
the settings.
6. Do not spill any corrosive chemicals or liquids on or
near the equipment.

7. Packing List
DX-T-22
Quick Guide
1Set
1Pcs
8. Notes:
In order to ensure the reliable use of equipment and the
safety of personnel, please follow below details when
installing, using and maintaining:
1. When the equipment is installed, ensure that the
ground wire in the power line is well grounded and
the connection point of the chassis is well grounded.
2. Keep the working environment well ventilated, so
that the heat generated by the equipment can be
discharged in time, so as not to damage the
equipment due to high temperature.
3. If the equipment is not used for a long time or in a
wet condensation environment, the main power
supply should be turned off.
4. Be sure to unplug the ac power cord of the
equipment from the power supply socket before the
following operations:
A. Remove or reload any part of the equipment.
B. Disconnect or reconnect any electrical plug or
connection to the device.
5. Non-professionals without permission, do not
dismantle the equipment without authorization, so
as to avoid the risk of electric shock. Do not repair, so
as not to increase the damage of the equipment.
Contact US
www.infobitav.com
[e-mail]