Ingersoll-Rand VR910M User manual

829560_00(2) Copyright © 2003 Ingersoll-Rand. All rights reserved.
FOR USE WITH MORTISE DEVICES
VR910M/VR914M VANDAL RESISTANT TRIM
INSTALLATION INSTRUCTIONS
INSTALL MORTISE LOCK. SEE MORTISE LOCK
INSTRUCTIONS.
INSTALL EXIT DEVICE AND TRIM.
3
4
RHR
SHOWN
LHR
OPPOSITE
VR910M/VR914M
TRIM
SCREWS (4):
10-24 X 1”
PPHMS SCREWS
(1-3/4” DOORS)
10-24 X 1-1/2”
PPHMS SCREWS
(2-1/4” DOORS)
INSTALLCYLINDER, IFUSING.
5
KEYHOLE
POSITION
WHEN INSTALLED
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR PROPER FIT
SET SCREW: REMOVE FROM CYLINDER
SIDE UNTIL CYLINDER IS SCREWED INTO
PLACE, THEN REINSTALL SCREW
CYLINDER COLLAR
3-1/2”
7”
3-1/2”
1-3/8”
13/32” DIAMETER HOLES,
4 PLACES (TRIM SIDE)
1/4” DIAMETER HOLES,
4 PLACES (OPPOSITE SIDE)
1-5/8” DIAMETER
HOLE (TRIM SIDE
OF DOOR) FOR
CYLINDERS ONLY
DEVICE & TRIM
HORIZONTAL
L
C
RHR SHOWN
LHROPPOSITE
OUTSIDEFACE
OF LOCK STILE
11/16”
PREPARE PUSH SIDE OF DOOR FOR EXIT
DEVICE.SEE EXITDEVICEINSTRUCTIONS
FORPREPARATION.
PREPARE PULL SIDE OF DOOR FOR TRIM.
ATRANSFERVERTICAL ANDHORIZONTAL
DEVICECENTER LINESFROM PUSHSIDE
OF DOOR TO PULL SIDE.
BLOCATE AND PREPARE ALL HOLES AS
INDICATEDBELOW.
1
2
DEVICE & TRIM
VERTICAL
L
C
2-1/4”