Innokin iTaste DRV User manual
WARNING:
1. The iTaste DRV is only intended for use by people
of legal smoking age (18+). The iTaste DRV is NOT
to be used by non-smokers, children, pregnant or
breaseeding women, people with or at risk of
heart disease or people taking medicaon for
depression or asthma. The iTaste DRV is neither
intended for use, nor marketed as, a smoking
cessaon device.
2. This unit may include small parts; Keep out of
reach of children and pets.
3. Please do not drop, throw, or mishandle your
iTaste DRV as you damage may be caused to the
outer shell or inner components. The DRV is
made of stainless steel however it may become
damaged when dropped or otherwise mishan-
dled.
4. Do not aempt to repair the unit by yourself as
damage or personal injury may occur.
5. In order to prolong the operaon of your iTaste
DRV, please do not place or store it in excessively
hot or cold environments.
6. Please obey local laws or regulaons while
vaping. If you are in an area where there are any
bans or potenal dangers, please do not use your
iTaste DRV.
7. Your iTaste DRV is not waterproof. Please keep it
dry at all mes. Please be aware that excessive
sources of heat may damage your iTaste DRV. Do
not leave your DRV in the car if the outside
temperature is excessively hot.
8. Innokin is not responsible for DRV or Tank
malfuncon or explosions caused by the use of
incorrect car charger power output. The iTaste
DRV uses 12/24DCV only; any other output will
damage your device.
9. Please power off the DRV when not being used.
The DRV and DRV Cord should not block or
interfere with any of the following:
• The Pedals or any of the controls in your car.
• Your view of the road or your car’s mirrors.
• The Airbag or other safety devices. Innokin provides a three month aer sales service
warranty to all of our authorized vendors.
Please consult Innokin official distributors for more
informaon and terms of service.
Innokin’s warranty does not apply to products
purchased through third-party vendors.
WARNING:
• Always obey state and local laws when operang
your vehicle.
• Do not use the DRV while driving your vehicle.
• You should be able to reach the DRV easily
without stretching or leaning.
• Always keep your full aenon on the road and
your surroundings when driving and keep two
hands on the steering wheel at all mes when
your vehicle is in operaon.
• Use common sense at all mes and do not
endanger those around you.
Technical Specificaons:
Power supply: Car charger light socket 12/24DCV
Standby current:
5mA max
Fuse: 5A/250VAC
Maximum output voltage:
6.4V (unloaded)
Maximum output current:
5.0A
Maximum output waage:
20W (Was mode)
Resistance of clearomizer: 1.0 Ohm (minimum)
Low voltage protecon:
9.6V
Overme Vaping Warning: 2600m Ah
Short Circuit Protecon: 0.6 +/-0.2 ohm
Please read the instrucons and precauons
carefully before using your iTaste DRV.
Warranty
Quick User Guide
1. Connect the output cable to the DRV body. Insert the
DRV into a DC12V or DC24V car charger socket. The
power indicator LED will flash 3 mes.
2. Press the ON/OFF switch. The power indicator light
and the rotaonal wheel indicator will light.
3. Adjust the rotaonal wheel to your desired voltage in
the following increments:
4.2V, 4.4V, 4.6V, 4.8V, 5.0V, 5.2V, 5.4V, 5.6V, 5.8V,
6.0V, 6.2V, 6.4V
4.
Aach the atomizer to the output port. The output
electricity board drive atomizer will be acvated and
the working indicator LED will light.
5. To power OFF: Press the ON/OFF switch again. The
power indicator light will turn off. The DRV will
power off and output will cease.
6. Short Circuit Protecon. If there is a short circuit the
1：Atomizer connecon port
2：Output port
3：Working indicator light
4：Output board
5：Output port
6：Output cable
7：Input port
8：Main body output
9：Rotaonal wheel
10：ON/OFF switch
11：Power LED
12：Rotaonal wheel indicator light
13：Main body
14：Input negave
15：Input posive
16：Manual switch part
The rotaonal wheel adjusts voltage in the following
increments:
4.2V, 4.4V, 4.6V, 4.8V, 5.0V, 5.2V, 5.4V, 5.6V, 5.8V,
6.0V, 6.2V, 6.4V
Scale display voltage improves intuive control and
provides more accurate performance.
FEATURES:
OPERATION GUIDE:
Scale Display Voltage:
Variable Voltage:
Power indicator light will flash 20 mes and a buzzer
will chirp 20 mes. The power indicator light will
switch off and the DRV will stop output.
7. Over rate vaping protecon: The power indicator LED
will flash and the buzzer chirp as a warning if the
vaping interval me is below 3 seconds aer having
be used/vaped 15 mes.
8. The rotaonal wheel LED will blink if the rotaonal
wheel is not correctly in place.
To set your desired voltage turn the rotaonal wheel
to the le or right unl you hear a click.
When adjusng the voltage with the rotaonal wheel
please check to ensure the wheel is set to the desired
voltage.
9. When the iTaste DRV has been powered on hold the
buon down to acvate the unit and commence
vaping.(Manual switch part)
2.
If the rotaonal wheel indicator light flashes
connuously please ensure that the rotaonal wheel
is correctly set in place.
3. If no vapor is produced please check that the output
cable is securely aached to the DRV and the
atomizer and that the indicator LED is lit.
4. If there is a burnt taste: please check if the atomizer
has enough e-juice and adjust the DRV rotaonal
wheel to a lower voltage seng.
Please ensure that you are using lower waage for
low-resistance (ohms) accessories and higher
waage for high-resistance (ohms) accessories.
5. If the buzzer is chirping please check to see if the
atomizer has a short circuit or if over rate vaping
protecon has been acvated.
1. If the power indicator does not light when you press
the ON/OFF buon please do the following:
Check that the DRV is securely fied into the car
charger socket and there is standard power output.
Following this check for fuse damage. Lastly the
ON/OFF buon, power indicator LED, or operaon
board may be malfunconing. In this case please
return the unit to your Authorized Innokin Vendor
for further informaon.
TROUBLESHOOTING:
12
3
4
5
16
6
715
14
13
8
9
10
11
12
