Innovative 9040 User manual

Step 4 Adjust Swivel Joints
Step 5 Adjust Platform Tilt
A tilt device is mounted underneath the keyboard platform. You can easily
adjust the angle of typing on your keyboard by turning the tilt knob to
either raise or lower the front of the platform.
Your assembly and modifications are complete. If you need additional assistance
regarding this product or if you need to return this arm for any reason, please
contact our customer service department at 800.524.2744 to obtain a Return
Authorization Number (R/A).
Model 9040
Keyboard Mechanism
Installation Instructions
© Innovative Office Products, Inc. 2004 IOP-502563
Innovative Office Products, Inc.
Innovative Office Products, Inc. |100 Kuebler Road| Easton, PA 18040
800.524.2744 | [e-mail]
Insert the 3/32” allen wrench (provided) into the appropriate set screw and
tighten or loosen to the desired degree of joint friction.
Base Mount
Platform Shaft
Tilt Knob

Step 1 Track Assembly
Step 2 Attaching Arm to Track
Step 3 Attach Keyboard Platform to Arm
Insert the shaft of the keyboard platform into the end of the keyboard
mechanism.
Step 4 Adjust Counter-balance
Be sure your keyboard is on the platform before making any adjustments.
Hold the arm down in a horizontal position. Insert the 1/4” allen wrench
into the hole of the end cap.
Screw the track onto the underside of the work surface using the 8 wood
screws that have been provided.
The end of the track can be mounted perpendicular toward the user or at
an angle; however, MUST be recessed in from the surface edge at least 1”.
Screw the base of the keyboard mechanism into the track with the 4 screws
found in your hardware pack.
Track
Mechanism
Attach with 4 screws
TIP: If the arm is to high and will not go
down, the weight is set to high and should be
lowered, use the counter-clockwise adjustment.
If the arm is to low and will not stay in the up
position, the weight is set to low and should
be increased, use the clockwise adjustment.
Keyboard
Platform