Innovative Mobile Plastic Sheeting Dispenser User manual

Smaller boxes fit inside upper and
lower box caps.
Install axle and wheel to Base Legs
Install handles as shown.Biceps this
large NOT required for assembly.
Insert Box Holder Upright into Lower
Box Cap Base. Tighten bolts firmly.
Upper Box Cap does not need to be
removed when installing sheeting.
Bolt Lower Box Cap Base to Base Leg
assembly.
Shows sheeting installed.
Larger boxes fit outside of upper
and lower box caps.
For a demonstration video, please visit: www.InnovativeTools.eu
Magnetic tape to
hold razor blade
Innovative Mobile Plastic Sheeting Dispenser™ Assembly Instructions
P/N I-MPSD
Helpful usage hints
1. When installing boxes, use the vertical position.
2. Cut flaps o of box ends before installing into holder.
3. When dispensing plastic horizontally, always have plastic dispense from top as shown above.
4. Plastic cuts best with straight razor blade against the factory box.

Innovative Mobile Plastic Sheeting Dispenser™
P/N I-MPSD
If you have any comments, questions or concerns about our products or are missing a part, please
contact us toll-free at 1-866-438-4884 or 651-415-0733 or visit www.innovativetools.com/contacts
REMOVE ALL BURRS AND BREAK ALL SHARP EDGES .015 R MAX UNLESS OTHERWISE NOTED. REMOVE ALL BURRS AND BREAK ALL SHARP EDGES .015 R MAX UNLESS OTHERWISE NOTED.
Plastic Knob
250-026
Qty: 1
Rubber Sleeve
250-027
Qty: 1
Rubber Post Cap
255-005
Qty: 4
Magnet Strip
990-919
Qty: 1
Upper Box Cap Assy.
990-920
Qty: 1
Box Holder Upright
255-008
Qty: 1
Handle
255-010
Qty: 1
Handle Support
255-009
Qty: 1
3/4End Cap
255-013
Qty: 2
1.25End Cap
255-012
Qty: 4
8Rubber Wheel
255-001
Qty: 2
1/2Flat Washer
255-002
Qty: 4
Lower Box Cap Assembly with Base
255-007
Qty: 1
Cotter Key
255-003
Qty: 2
17Axle Shaft
255-004
Qty: 1
1End Cap
255-011
Qty: 2
Base Leg
255-006
Qty: 2