Ignite Wired
Press and hold 'CH MODE' and 'BOOST CH' keys together on
the Room Thermostat until C5
is displayed.
Ignite Wireless (March 2021 onwards)
Long press BOTH buttons on the Receiver until '1 and WiFi'
lights lash.
Using the LEFT button, cycle through the menu until 'CH'
lashes.
Press the RIGHT button, 'CH' will rapidly lash.
Ignite Wireless (March 2021 and earlier)
Short press the pairing (middle) button on the Relay
Module, this will make all three lights
lash green.
Then press the CH button, The CH button will now lash
green.
Ignite Wireless (3ch2,3ch)
Long press the two outside buttons on the Relay Module,
this will make all three lights lash
green.
Then press the CH button, The CH button will now lash
green.
Smart Sensor
Press and hold \/ button or 5 seconds. All 5 LED's will slowly
lash to indicate unit is in pairing mode.
Upon success ul pairing, the centre LED on the Smart Sensor
will rapidly lash.
I pairing ails, the two outside LED's will rapidly lash. Please
try the pairing procedure again.
