Intellitronix S9020 User manual

Installation Guide
GPS Speedometer Sending Unit
Programmable with High Speed Recall
Part Number: S9020
Please note that due to continuing improvements the actual product may differ slightly from the photos.
Your Kit Contains
•(1) S9020 GPS speedometer sending unit
with antenna
Wiring Instructions
Notes:
1) Please be sure to read our ‘Before You Begin’ page before proceeding – it contains important
information about your installation.
2) This unit’s antenna MUST have a clear view of the sky for proper GPS signal reception.
Connections are as follows:
•Black Wire – Ground
Connecting this wire to the engine block.
•Red Wire – Power
Connect to a switched +12V source such as the ignition. Line should have power when key is ‘on’ or
in the ‘accessory’ position.
•S eedometer
There are three different pulse-per-mile (PPM) wires on the sender each designated by specific color.
To match this sender to the PPM your speedometer expects connect the proper wire to your
speedometer as follows:
GPS Sender Wire Color Pulses-Per-Mile (PPM)
Blue 16 000
White 8 000
Orange 4 000
If you are using an Intellitronix gauge/dash you will connect the White Wire from the sender to
the White Wire on the gauge/dash.
Page: 1 of 2
© 2023 Intellitronix / Intellitronix.com
All rights reserved.
GPS Speedometer
Sending Unit
Installation Guide
S9020-IG
Revision: 2023.12.16A

O eration
The first time the unit is turned on it may take up to a few minutes to detect its location and
begin communicating with the speedometer circuit.
•Status LED
◦Flashing - the unit is NOT receiving any GPS data from the satellites.
◦Steady - the unit is receiving GPS data from the satellites.
•Momentary Switch (gray wires with attached ushbutton)
Press the button to have the speedometer display the highest speed recorded since the current
startup.
Page: 2 of 2
© 2023 Intellitronix / Intellitronix.com
All rights reserved.
GPS Speedometer
Sending Unit
Installation Guide
S9020-IG