TigerTough 75712 User manual

INSTALLATION GUIDE
75712 REAR SEAT
JEEP WRANGLER JL BENCH

For assistance with installation, call us at 507.246.3545
BILL OF MATERIALS
ITEMITEM QUANTITY
Seat Back Cover 1
Seat Bottom Cover 1
Headrest Cover 2
General care instructions:
1. In most cases dirt, debris, spills and pet hair can be removed by wiping with a
damp cloth.
2. Seat covers can be removed and machine washed on low temperature setting
using mild detergent.
Drip dry or machine tumble dry on a no heat cycle.
Straps should be coiled and secured with rubber bands for machine washing
and drying.
3. Soil may be removed with spray cleaner or detergent and water.
4. Oil or grease stains should rst be treated with a dry cleaning solvent followed
by a spray cleaner or detergent and water.
5. Do not use bleach.
Watch the installation video at ttcovers.com/75712video

For assistance with installation, call us at 507.246.3545
Your new seat covers are covered by a
two-year, unconditional, no B.S. warranty.
That means that if you manage to abuse
them to a point that they can’t perform like
they’re supposed to within two years of when
you bought them, we’ll make it right.
Depending on what is more practical, we’ll
either repair or replace the damaged cover.
Register your seat covers at:
ttcovers.com/RegisterMyCovers
Basically, you break it, we buy it.
Seriously.

For assistance with installation, call us at 507.246.3545
Driver’s Side
Place the smaller
seat bottom
coverover the
driver’s side
portion of the
bench.
1
4
Run ap from
the front of cover
around to back of
cover. Tuck ap
near the back
between seat
back and bottom.
Fasten front,
back and side
aps together
underneath the
seat.
Turn the seat
back cover
3/4 of the way
inside out, over
headrest.
Work down the
seat back with
the TigerTough
tag facing the
door.
Fasten velcro
under the
headrest, and
fasten the velcro
aps at the
bottom of the
seat back.
Slide headrest
cover on and
fasten velcro
together
underneath.
5
6
7
2
Adjust as
neccessary for a
good t.
3

For assistance with installation, call us at 507.246.3545
Passenger’s Side Cover
Undo all velcro
and work the
cover over the
headrest. Pull
seat belt out
and push cover
behind the seat
belt.
1
2
3
4
Flip the seat
forward and
fasten the back
pieces together
where the velcro
meet. Then, pull
the aps that
were pushed
through from the
front and fasten
them to the velcro
on the back.
Adjust cover on
the seat back so
that the edges
and seams
line up with the
factory edges
and seams. Push
aps between the
seat back and
bottom.
Fasten velcro
under headrest.
Adjust cover as
neccessary for a
good t.
Place seat
bottom cover
on the seat and
arrange it so that
the edges line up.
Run the ap
from the front
under the seat to
the back. Push
the other ap
between the seat
back and bottom.
Fasten aps
together under
the seat.
5
6
7
8