Intermec PB2 Series User manual

Use the protective case to transport and store your PB2X and PB3X printer.
The protective case provides easy access to the printer buttons, connectors,
and battery, allowing you to print labels while the printer is still in the
protective case. Use the handstrap or shoulder strap accessory with the
protective case to make it easy to carry. The protective case kit contains these
parts:
•Protective case accessory
•This instruction sheet
To detach the belt clip from the printer
1Rotate the belt clip 180 degrees and pull it away from the printer.
2Remove the two Phillips screws on the back of the printer.
PB2X|PB3X
Protective Case Instructions

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
© 2010 Intermec Technologies
Corporation. All rights reserved.
PB2X and PB3X Protective Case Instructions
*943-223-002*
P/N 943-223-002
To insert the printer into the protective case
1Unzip the main flap on the protective case and insert the printer with the
control panel facing upward.
2Close the zippers on the protective case and secure the flap over the printer. You
can:
•open the media flap to print labels while the printer is in the case.
•open the card reader flap to use the card reader.
•open the communications flap to attach a power cable, USB cable, or a serial
cable to the printer.
Card reader flap
Communications flap
Media flap