Interphone F4XT User manual

9
1
7
5
6
8
4
3
2
F4XT
F3XT
8
B
B
A
A
B
B
A
A
www.interphone.cellularline.com
A
B C
A
A
B
B
B
A
B
10
QUICK GUIDE EN
A- YELLOW
B - GREEN
WE RECOMMEND YOU CHECK FOR
SOFTWARE UPDATES ON THE WEBSITE
WWW.INTERPHONE.CELLULARLINE.COM
1 - MFB (multifunction button)
2 - UP button
3 - DOWN button
4 - + volume button
5 - – volume button
7 - Multifunction LED
7 - Multifunction LED
8 - Multifunction audio/data port
9 - Mounting guides for Bluetooth® module
10 - Charging/audio-in connector
*see the user manual
for complete instructions.
ASSEMBLY OF THE SLIDE SUPPORT
WITH REMOVABLE CLIP
Take the support and note the best place
to fasten it to the side of the helmet. Insert
the rear part of the clip into the helmet and
attach the other part on the outside.
ASSEMBLY OF THE ADHESIVE SLIDE
SUPPORT
Take the adhesive support and look for the
best side and place to position it. Clean and
de-grease the part of the helmet where you
are going to stick the support (do not use
any detergents that could damage the hel-
Insert the screws and
tighten gently. Check
position and move the
support if necessary by sli-
ding it along. Tighten the
screws with the screwdri-
ver supplied.
(images A/B)
met’s finish). Remove the
protective film from the
double sided tape, and
apply the support to the
helmet.
As the support cannot be
moved once it is attached
to the helmet, take great
care with its positioning
when applying.
(image C)
MOUNTING ON
FULLFACE HELMET
MOUNTING ON
MODULAR HELMET
MOUNTING ON
OPEN FACE HELMET
MOUNTING ON
FULLFACE HELMET
MOUNTING ON
MODULAR AND
OPENFACE
HELMETS
PHASE 1
PHASE 1
PHASE 3
PHASE 2
PHASE 4
PHASE 3 PHASE 4
PHASE 2

SSCGALAXYS3
SMGALAXYS3
*
*
MICINTERPHOXTUNIREMOTECONTROLF
*
ACHUSBCOMPACT MICROCBRINTERPHXT
SMIPHONE5 SSCIPHONE5
DOWN
+–
UP
press
MFB
DOWN
+
UP
press
MFB
–
MFB
UP
DOWN
VOL. +
VOL. –
*
ACCMOTOADAPTERMICROCBRUSBDUAL
KITSPINTERPHONEF5 TESTKITXT
GUIDARAPIDAF3F4XT
CUSBINTERPHONEF5
USBCHXT25
www.interphone.cellularline.com - www.cellularline.com
Export Dept. [email protected]
Thank you for choosing our products.
Before using this product, we recommend you carefully perform the operations
outlined in this Quick Guide.
1 - Charging
Insert the recharging cable in the audio connector kit as shown in the figure.
Insert the other end of the cable in a standard USB port.
With the double jack
you can charge two
Interphone XTs
at the same time.
The LED lights up yellow/orange during charging.
The LED turns green when charging is complete.
When charging is complete, disconnect the units from the charger by pulling out
the jack plug, and also unplug the charger from the outlet.
2 - Pairing method
Press and hold down the MFB button. After a few seconds, the blue LED will light
up. Hold down the button for three more seconds. The red LED will also light up,
and the two LEDs will flash with an alternating red/blue light. Now, release the
button.
Now you are ready to connect to a phone or other Interphone.
3 - Connecting to a phone
From the Bluetooth menu on your mobile phone (such as the sample iPhone menu
shown below), search for a new device.
When the device is found, select Interphone F..XT. Connection will take place auto-
matically after a few seconds.
If a password is required, enter 0000.
4 - Connection between two Interphones
Repeat step 2 for the second Interphone.
The LEDs on the two Interphones will both flash red and blue.
Press the centre button on one of the two Interphones to activate the search proce-
dure.
The LED will flash more quickly, indicating that the device search is in progress. After
around 10 seconds, the Interphones will find each other and pair automatically.
Now, the LEDs will light up a steady blue, which shows that intercom communication
is established.
Press the centre button on one of the two units one time to switch off
intercom communication.
To change the function, press MFB until you hear the beep.
Interphone F..XT
Interphone F..XT
Interphone F..XT
INTERPHONEXT ACCESSORIESRECOMMENDED ACCESSORIES
*not included
AC 220/110 - USB ADAPTOR
EMERGENCY BATTERY
USB PORT
MFB BUTTON
ON  press for 3 seconds
OFF - press for 5 seconds
INTERCOM/ON - press briefly
INTERCOM/OFF - press briefly
VOICE CALL/ON -hold down until you hear the beep (3 seconds)
VOICE CALL/OFF - hold down until you hear the beep (3 seconds)
UP BUTTON
MUSIC/PLAY  hold down until you hear the beep (3 seconds)
MUSIC/PAUSE  hold down until you hear the beep (3 seconds)
NEXT SONG  press briefly
DOWN BUTTON
BEGIN SONG  press once
NEXT SONG  press once or twice
F4XT - F3XT BUTTON DIAGRAM
*F5 not included
* Interphone
not included
+ VOLUME BUTTON
INCREASE VOLUME  press multiple times
ENABLE VOICE RESPONSE  hold down until you hear the beep (9 sec.)
 VOLUME BUTTON
REDUCE VOLUME  press multiple times
MUTE/ ON - hold down until you hear the beep (3 sec.)
MUTE/OFF - press briefly
DISABLE VOICE RESPONSE  hold down until you hear the beep (9 sec.)