Interphone SHAPE User manual

SHAPE

WARNING ON THE BATTERY OF THE PRODUCT
Fully charge the battery before using the product for the first time.
Do not store the Product without charging it. Failure to do so may cause irreversible damage to
the battery capacity. Charge the battery every TWO months.
WARNING ON THE WATER RESISTANCE OF THE PRODUCT
The external unit (control unit), connected to the audio kit, is classified IP67 according to the
IEC60529 standard. The control unit, can therefore be immersed in a meter of fresh water for a
maximum of 30 (thirty) minutes.
Despite this classification, the device is not immune to greater stress, such as prolonged
immersions or high pressure water jets.
Using the product during intense meteorological phenomena, at high speeds, may be equivalent
to subjecting the product to a high pressure jet.
FOLLOW ALL SUGGESTIONS CAREFULLY TO AVOID DAMAGING THE DEVICE:
Do not immerse the product in fresh water which is more than a metre deep for more than 30
minutes.
Do not store the product when still wet: dry it with a clean, soft cloth.
Do not expose the product to salt water or ionised water, drinks or other liquids.
If the device is exposed to liquids other than fresh water, wash the device with cold fresh water
and dry it carefully with a clean, soft cloth.
Do not expose the product to high pressure water jets.
CHAPTER 1 –COMPOSITION OF THE KIT
MFB (ON/OFF)
VOL +
VOL -
Bluetooth unit

CHAPTER 3 - BATTERY CHARGE
Insert the micro USB charging cable in the special intercom connector, as shown in the
picture. Connect the cable to a standard USB charger.
LED indications:
- red LED: charging.
- green LED: fully charged
CHAPTER 4 - BASIC CONFIGURATION
Turn the device on
Press MFB until the blue LED comes on.
Turn the device off
Press MFB until the red LED lights up and the device turns off.
Activate / Deactivate automatic volume control
1. With the device off, press MFB until the second beep. Led will flash red/blue.
2. To activate, press Volume + until the first beep. Led will flash green for 4 seconds.
3. To deactivate, press Volume - until the first beep. Led will flash red for 4 seconds.
Activate / Deactivate phone calls voice answer
1. With the device off, press MFB until the second beep. Led will flash red/blue.
2. To activate, press Volume + until the second beep. Led will flash green for 4 seconds.
3. To deactivate, press Volume - until the second beep. Led will flash red for 4 seconds.
Factory Reset
With the device off, press together MFB and Volume + and Volume –until the device switches on. All
settings and pairings will be erased.
CHAPTER 5 - TELEPHONE / GPS
Pairing
1. With the device off, press MFB until the second beep. Led will flash red/blue.
2. Start searching for new devices on the mobile phone / GPS
3. Select the intercom on the phone / GPS “interphone shape”.

4. Once the pairing has been confirmed, the LED will flash BLUE twice, every three
seconds.
Answering a call
Just say loudly “HELLO” or short press MFB
Voice dial
Short press MFB
Redial last number
Double press MFB
CHAPTER 6 –MUSIC
Enable/disable playback from the phone
Press MFB until the second beep.
Next track
On music playback, press Volume + until the first beep.
Previous track
On music playback, press Volume - until the first beep.
Share the music with another intercom
On music playback, press Volume + until the second beep. To stop sharing, press Volume - until the
second beep.
CHAPTER 7 –INTERCOM
Pairing with another Interphone device (for the first time only)
1. With both the intercom devices off, on each unit press power-on button until led will flash
red/blue.
2. Press once MFB button on Interphone SHAPE, units will pair and connect.
Pairing with a NON-Interphone device (for the first time only)
1. In the NON-Interphone unit, start the telephone search/pairing mode; refer to the user manual of
the intercom to be paired.
2. With Interphone SHAPE off, press MFB until led will flash red/blue.
3. Press once MFB button on Interphone SHAPE, units will pair and connect.
Two way intercom talk
On one unit only, press MFB until the first beep.
To stop communication, on one unit only, press MFB until the first beep.

TECHNICAL CHARACTERISTICS
Bluetooth® compliance: Bluetooth v. 3.0 - Class II
Supported Bluetooth profiles: HFP A2DP AVRCP
Frequency: 2.402 –2.480GHz
Power: 4dBm EIRP
Operating temperature: 0 –45°C
Charging temperature: 10 - 45°C
Dimensions mm: 36x78x18
Weight: 50 g
Capacity: Up to 10 meters
Talk time: 12 h
Stand-by time: 700 h
Charging time: 3 h
Battery type: Lithium-ion rechargeable
SAR is measured with the device at 0 mm to the body, while transmitting at the highest certified output
power level in all frequency bands of the device. The maximum SAR value is 1.75 W/kg (head/body)
averaged over 10 gram of tissue.
WARNING: To prevent possible hearing damage, do not listen at high volume levels for long periods.
EN - Hereby, Cellular Italia S.p.A declares that the radio equipment type BTF6 (Interphone Tour, Sport and
Link) is in compliance with
Directive 2014/53/EU and Directive ROHS (2011/65/EU). The user is prohibited from making any type of
change or variation to the device.
Variations or changes not expressly approved by Cellular Italia S.p.A will cancel the user’s authorisation to
use the device.
Only update with software provided by Cellular Italia S.p.A.
Bluetooth® is a trademark owned by Bluetooth SIG, Inc.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.cellularline.com/it_it/dichiarazione-conformita/
EN - INSTRUCTIONS FOR THE DISPOSAL OF APPLIANCES FOR DOMESTIC USERS

(Applicable in countries in the European Union and those with separate waste collection systems)
This mark on the product or documentation indicates that this product must not be disposed of with other
household waste at the end of
its life. To avoid any damage to health or the environment due to improper disposal of waste, the user
must separate this product from
other types of waste and recycle it in a responsible manner to promote the sustainable re-use of the
material resources.
Domestic users should contact the dealer where they purchased the product or the local government office
for all the information
regarding separate waste collection and recycling for this type of product. Corporate users should contact
the supplier and verify the
terms and conditions in the purchase contract. This product must not be mixed with other commercial
waste.
This product has a battery than cannot be replaced by the user. Do not attempt to open the device to
remove the battery as this could
cause malfunctions and seriously damage the product. When disposing of the product, please contact the
local waste disposal authority
to remove the battery. The battery inside the device was designed to be able to be used during the entire
life cycle of the product