INVERTO.TV MultiConnect System User manual

Installation Guide
MultiConnect™System
IDLB-SET03-MULTI-8TP
Starter Kit for multiple Single and/or Twin LNBs installation

Thank you for purchasing Inverto’s innovative MultiConnect system and we are certain it will meet your
expectations.
Before installing the system, please read the following instructions and recommendations. We suggest
that you keep this manual for future use.
System description
The MultiConnect system supports reception of
multiple satellites with any universal dish antenna. The
following diagram depicts the system architecture:
The system is based on unique LNB designs and a set of mounting parts provided in kits to support
numerous installation scenarios.
Thanks to the slim feed technology of the MultiConnect LNBs, the MultiConnect system supports a
remarkable reception span of multiple satellites from 2 to 30 degrees spacing depending on the actual
dish size:
Dish antenna size Minimum spacing between satellites Maximum spacing between satellites
60cm ( ) 3 degrees 30 degrees
80cm ( ) 2 degrees 22 degrees
The system is mounted over a central LNB that is fixed to the satellite antenna’s LNB feed holder.
Since most LNB feed holders are designed for 40mm LNBs, there is a 23mm to 40mm ring adaptor
supplied with the LNBs. Each MultiConnect LNB incorporates a built-in inner block behind its back
cover. The inner block contains a bolt and together with the supplied screw tightens the LNB to the
multi-feed arc bracket:
2

Due to the unique design of the inner block and the corresponding mounting parts, the MultiConnect
LNBs can rotate on all axes and set on the optimal position for best signal reception. The LNBs can
move up/down, left/right, in/out-ward the focal point and rotate clock/anti-clock wise:
The Starter Kit
The Starter kit supports simple installations of up to 5 MultiConnect Single or Twin LNBs on any uni-
versal dish antenna.
The following table lists all the parts supplied in this kit:
Part description Quantity
supplied
Part diagram
Spacer 5
Long extender 5
Long screw 5
Multifeed arc bracket 1
Hex wrench 1
3

System installation
The following diagram shows the system elements and shall assist you when installing your system:
Note: The multifeed arc bracket is marked with tags spaced by 3 degrees - referenced to the position
of the central LNB - to allow quick adjustment of the LNB’s azimuth. The arc bracket has two lines of
marks - one for 60cm dish antennas and the second for 80cm dish antennas.
Disposal
Following relevant EU directives, this device shall not be disposed of together with municipal waste.
Use local waste collection and recycling systems to dispose wore out products.
*DiSEqC™ is a registered trademark of Eutelsat
Available MultiConnect LNBs & Kits:
IDLB-SINL20-MULTI-0PP - MultiConnect Single
IDLB-TWNL20-MULTI-0PP - MultiConnect Twin
IDLB-QUDL20-MULTI-0PP - MultiConnect Quad
IDLB-QUTL20-MULTI-0PP - MultiConnect Quattro
IDLB-SET01-MULTI-STP - Base kit for installing up to 4 Single or Twin MultiConnect LNBs on
universal dish antennas including DiSEqC switches and RF cables.
IDLB-SET02-MULTI-QQP - Expansion kit for installations with up to 4 MultiConnect Quad or Quattro
LNBs including DiSEqC switches and RF cables.
4
V081208
80cm
60cm
80cm
60cm
60cm
80cm
+3˚+6˚+9˚-9˚-6˚-3˚
-9˚-12˚-15˚-6˚-3˚+9˚+6˚+3˚+12˚+15˚