inVue DNL203-W User manual

DNL203-W
Merchandising Guide
Use a charged and coded
OneKEY to deactivate the inVue
product that the sensor is plugged
into. For Zips Alarm Units, place
the OneKEY onto the IR lens and
press the button. Then place the
magnet key onto the lock icon on
alarm unit above the sensor. Push
in slightly and unplug the sensor.
1a If using the S2865 system, place the
charged and coded OneKEY onto
the Remote IR Dot connected to the
system and press the button. Remove
the sensor from the S2865 Alarm/
Power Box.
1b Peel the clear mylar strip from both
sides of the device and sensor.
2
1
2
5Unplug the OEM power supply from
the port on the sensor cable.
Note: The sensor is now ready to be
reinstalled. Consult the installation
guide for more information.
Use an alcohol wipe to remove any
adhesive residue on the device and
sensor.
3
CONTENTS: One pad saturated in 75%
Isopropyl Alcohol
DIRECTIONS: Apply topically as
needed to cleanse surface mounting area.
FOR EXTERNAL USE ONLY
KEEP OUT OF REACH OF
CHILDREN
KEEP AWAY FROM EYES
AND FIRE
4Unplug the sensor from the device.
© 2022 InVue Security Products Inc. All rights reserved.
InVue is a registered trademark of InVue Security Products.
Rev0 08/15/22
www.invue.com
NA / LATAM // 704.752.6513 •888.55.INVUE
EMEA // +31.23.8900150
APAC // +852.3127.6811
Note: If reinstalling the sensor with new
mylar strips, new strips are included in the
ADH2131 kit.