ipf electronic VY200120 User manual

VY200120
Counters, Pulse counters
Iprogrammable timer for on and off delay
Idirect adaption between sensor and cable socket
Ifactory setting 100ms off delayed
TECHNICAL DATA
dimensions Ø20 x 60mm
time range 1 … 65535ms
operating voltage 10 … 30V DC
residual ripple ≤ 10% of UB
current consumption (w/o load) < 10mA
input resistance > 10kΩ
switching output PNP transistor
output current (max. load) 400mA
short-circuit protection +
display (function) LED red
input frequency (pulse:pause = 1:1) ≤ 10kHz
input pulse width ≥ 50µs
temperature (operating) 0 … 60°C
temperature (storage) -20 … +60°C
degree of protection IP 67 (EN 60529)
housing plastic PBTP / PA
connection M12-socket / M12-connector, 4-pin
Connection Dimensional drawing
Colors: 1 brown, 2 white, 3 blue, 4 black
easy programming via external teach-
in no additional installation necessary
MANUAL •Subject to alteration! Version: October 2017
ipf electronic gmbh •Rosmarter Allee 14 •58762 Altena
│
Tel [phone] •Fax [phone]
│
[email protected] •www.ipf-electronic.com 1
068-14808

Adjustment and programming
On delay:1. Connect the sensor with the M12-socket of the time module and switch on the operating voltage.
The connection can be made by a 4-wire cable socket, e.g. VK200321.
2. Connect the teach input A (PIN 2, white) to +UB(PIN 1, brown).
3. Activate the sensor. The time the sensor is activated corresponds to the delay at a later time.
4. Release the teach-input from +UB.
Off delay:1. Connect the sensor with the M12-socket of the time module and switch on the operating voltage.
The connection can be made by a 4-wire cable socket, e.g. VK200321.
2. Activate the sensor.
3. Connect the teach input A (PIN 2, white) with +UB(PIN 1, brown).
4. Disconnect the sensor. The time the sensor is not activated corresponds to the delay at a later
time. If you wish an off delay of 4s, disconnect the sensor for 4s and activate it again.
5. Disconnect the teach-input from +UB.
Reset to factory settings:Connect the teach input A (PIN 2, white) for at least 10s to +UB(PIN 1, brown). During this time
the sensors’s state must not be changed! The device operates now with an off delay
of 100ms.
SAFETY WARNINGS:
Before initial operation, please make sure to follow all safety instructions that may be provided in the product infor-
mation!
Never use these articles in applications where the safety of a person depends on their functionality.
MANUAL •Subject to alteration! Version: October 2017
ipf electronic gmbh •Rosmarter Allee 14 •58762 Altena
│
Tel [phone] •Fax [phone]
│
[email protected] •www.ipf-electronic.com 2