ipf EXP Series User manual

EXPRoofRackAwningStay
InstallationManual
③
2.InserttheAwningstayintothehexbolts,
2.andsetpreferredmountingposition.Tighten
2.theAwningstaywithwashersandnuts,and
2.placethecornercapbackinplace.
1.RemovethecornercapfromEXProofrack
1.andinsertthethreehexboltssuppliedinto
1.theslotasshowninthefigureright.
Fittheawningstay
ontothesideframe Hexbolt
Slotchannel
Sideframe
ThankyouforpurchasingIPFEXProofrack.
Pleasereadthismanualcarefullypriortoinstallationtofollowcorrectfittingprocedure.
Storethismanualinsafelocationforfuturereference.
Handlingprecautions Caution
・Strictlyfollowtheinstallationmanual.Incorrectinstallationcausesdamageorlosstoyourvehicle.
・Noliabilityisacceptedforaccidentsordamagetoyourvehicleorproductcausedbyinstallationmethodsother
・ thanthose・describedinthismanual.
・Thisproductmustnotbemodifiedinanyway.
・Itisrecommendedthatthisproductbeinstalledbyaprofessional.
・ Installationmustbedonebytwoormorepersons.Pleasetakecaretoavoidfallingwhenusingastepladderetc.
・Turnofftheengineandignitionbeforeinstallation.
・DONOTputyourweightonthevehiclewithyourhands.Vehiclebodypanels,aroofpanelinparticular,caneasily
・ bedeformed・ordamagedbytheweight.
・Takecaretoavoidfallingwhenusingastepladder.
・Makesuretoprotectyourvehiclefromcorrosionwithtouch-uppaintetc.,iftheinstallationofthisproductcaused
・ anydamageto・yourvehicle.
・DONOTusearopeorbeltontheAwningstay.Vibrationcausesthemtomoveandbecomeloose,andexcessive
・ tensioncandamagethe・slotchannel.
・ ThisproductisdesignedforuseonlywithARBAwnings(PVCbag)orRhino-RackSunseekerAwnings.
Componentparts
Howtoinstall
PN:
EXR-08P
Awningstay
Nut
Washer
Awningstay
HexboltM 8×2 0
NutM8
WasherM 8×1 8
Nutcap
HexboltM 6×2 0
FlangenutM6
PlateBoltM 8×2 0
NutM8
WasherM 8×2 0
No.ofpcs
Partname
Note
Mountingholes
№
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
3
6
6
6
6
3
3
2
2
2
UP
Selectmountingholes
wheretheawning
staywillnotcome
intocontactwith
yourvehicleor
roofrack.
④
⑦
⑩
③
⑥
⑨
②
①
⑤
⑧
Note:Becarefulnottoconfuseboltsandnuts.
PartsusedforARBAwnings(PVCbag)
PartsusedforRhino-RackSunseekerAwnings

④
1．Checktoseeifanyboltsornutsareleftuntightenedorloose.
2.Periodicallycheckallboltsandnutstoseeiftheyareloose,andretightenifneeded.
2656 KURAGANO-MACHI TAKASAKI-CITY GUNMA-PREF 370-1201 JAPAN
Checkafterinstallation
Awning
ARBSideAwningmountingholes
3.Aftersecuringyourawning,fitthenutcaps
ontohexbolts,nutsandwashers.
Pleaserefertotheinstructionsofyour
awningforthelengthofoverhang.
Awningsfitting
Rhino-RackAwningmountingholes
UsethreeM6holesoneachstay
UsetwoM8holesoneachstay
ForARBSideAwnings(PVCbag)
ForARBSideAwnings(PVCbag)
ForRhino-RackSunseekerAwningsForRhino-RackSunseekerAwnings
Note
Note
Recommended tightening torque for nuts : 10 N-m
☆☆
・Pleaserefertotheinstructionsfor
・ fittingyourawning.
・Usetheboltsandnuts(⑥-⑩)to
・ attachtotheAwningstayinthecenter.
Awningstayinthecenter
Awning
Overhang Overhang
Nut
Nutcap