ipNX Linksys ATA SPA2102 User manual
www.ipnxnigeria.net
ipNX
Linksys ATA (SPA2102)
Setup Guide
•Phone 1 & 2: Use this port to connect one or two analogue telephones via an RJ-11 (i.e.
regular) fixed telephone cable.
•thernet: The thernet port connects to your internet device, such as a PC, laptop, wireless
router or switch, via an thernet network cable.
•Internet: The Internet port connects to your cable or DSL modem.
•Power: The power port is where the ATA power adapter is connected.
www.ipnxnigeria.net
ipNX
Step 1
Power off your network devices, including your modem and PC then connect the RJ-11 phone cable to the ATA's
Phone 1 port (and port 2 if you have 2 lines). Connect the other end to your analogue telephone(s).
Step 2
Connect one end of an thernet network cable (included) to the thernet port of the ATA. Connect the other end to
the thernet port of your PC.
Step 3
Connect one end of a different thernet network cable to the Internet port of the ATA. Connect the other end to
your cable/DSL modem then power on the broadband modem.
Step 4
Connect the included power adapter to the ATA’s power port, and then plug the power adapter into an electrical
outlet. The power L D on the front panel will light up as soon as the ATA powers on. Afterwards, power on your PC.
Step 5
Launch the web browser on the PC and type
http://192.168.0.1/admin/resync?http://cfg.ipnxtelecoms.com:80/spa/00012345ABCD.xml on the address bar.
Replace the 00012345ABCD with the actual MAC Address found underneath the ATA. The ATA will reboot in about
20-30 seconds. Pick the phone handset and listen for a dial tone. Dial 129 and listen for the voice prompt which will
read out your number (save where necessary).
At this point you should be able to make calls. Please ensure you have credited your line before making outbound
(i.e. off-net) calls. For your account balance dial 123.
For further assistance with the ATA setup, contact us via: support@ipnxnigeria.net, www.ipnxnigeria.net or +234 (1)
628 1111
Table of contents
