IQAir AirVisual Pro User manual

User Guide

2
Table of contents
Introduction
Meet the AirVisual Pro........................ 3
Important Safety Instructions ........... 4
Operating instructions
Getting started...................................12
AirVisual Pro controls........................13
Home screen......................................14
Indoor screen .....................................16
Forecast screen .................................17
Recommendations screen................18
Advice and status icons....................19
Air Quality Index (AQI) icons ............ 20
CO2 icons........................................... 21
Care & maintenance ......................... 22
Air Quality introduction & FAQ’s
Air Quality Index (AQI) ..................... 23
PM2.5 introduction........................... 24
CO2 introduction ............................... 25
Temperature & humidity................... 26
FAQ - View PM2.5 concentration..... 27
FAQ - Factory reset ........................... 28
FAQ - Sleep mode.............................. 29
FAQ - Serial number.......................... 30
Join the AirVisual Community......... 31

3
Meet the AirVisual Pro
Congratulations!
You are about to take the rst step to improving the air you breathe!
The AirVisual Pro is a comprehensive solution to optimize health and wellbeing
through clean and fresh air.
By combining laser technology and articial intelligence, your AirVisual Pro
is able
to deliver immediate and accurate air quality measurements, as well as intuitive
recommendations based on both your indoor and outdoor environments.
Use the AirVisual Pro to see invisible threats in your air and understand where they
come from. Learn more: iqair.com
Please study this User Guide carefully to familiarize yourself with the special
features and functions of this IQAir product. Keep this document in a safe place for
future reference.

4
WARNINGS
Do not drop, disassemble, open,
crush, bend, deform, puncture,
shred, microwave, incinerate, paint,
submerge in a liquid, damage,
modify, overload the outputs of
or insert foreign objects into the
product. Do not use the product
anymore if an object has fallen on
it or it has fallen on the oor.
Keep product out of the reach
of children. Children shall be
supervised when using the
product.
Do not expose product to heat,
re, rain or snow. Do not store in
direct sunlight or in a vehicle.
Do not use a damaged cable
or non-tting connector and do
not use or charge a damaged
product or a product with reduced
capacity of the internal battery.
In the event of leaking of internal
battery, keep away from skin and
eyes. Wash any affected area
with large amounts of water and
seek medical attention. In case of
damage or reduced capacity of
the internal battery take product
to a qualied service person/
manufacturer.
Important safety information

5
The product needs to be charged
before use. Do not leave the
product on prolonged charge
when not in use. Disconnect the
product from the charger/adapter
once full. Store the product in a
cool, dry place when not in use.
When the product is not used
for prolonged periods, it shall be
charged periodically in order to
maintain the internal battery’s life.
Do not use any charger/adapter
or cable other than that provided
by the manufacturer and do not
charge the product unattended.
Keep all instructions provided with
the product for future reference.
Equipment and accessories
are to be supplied by IQAir or its
agent only. Use of equipment,
components and accessories
other than those specied by
IQAir may impair the safety
provided by the equipment. This
equipment is to be operated with
provided accessories only. Safety
of any system incorporating the
equipment is the responsibility of
the installer of the system. If the
AirVisual Pro is used in a manner
not specied by the manufacturer,
the protection provided by the
equipment may be impaired.
Important safety information

6
This equipment is intended for use
at supply voltages with uctuations
not exceeding +/-10 % and
classied as over voltage category
II. This equipment is intended for
use in environments classied as
pollution degree 2 and it is not to
be stored or used in wet locations.
The USB adapter is not to be
positioned so that it is difcult to
be unplugged.
This equipment is to be cleaned
with a damp cleaning cloth with
warm water containing a drop
of dishwashing detergent. After
cleaning, dry it with a cloth.
CAUTION
The AirVisual Pro and its
accessories are not intended for
outdoor use. The AirVisual Pro
enclosure is not weatherproof or
waterproof. Any water that enters
the inner compartment will likely
severely damage the AirVisual Pro
and may present a safety hazard.
Before plugging the USB adapter
into a socket, check if voltage and
frequency corresponds to 100 to
240 V and to 50 to 60 Hz. Do not
use the equipment at altitudes
exceeding 2’000 meters (6’560
feet). DO NOT remove any parts
Important safety information

7
from the IQAir AirVisual Pro. There
are no outputs available from the
IQAir AirVisual Pro.
The AirVisual Pro and its USB
adapter is rated to operate
between -10°C and +40°C (14°F to
104°F) with humidity ranging from
0% to 95% non-condensing.
LASER SAFETY
The AirVisual Pro contains
a PM sensor module that is
classied as a Class 1 laser-based
instrument. DO NOT open the
PM sensor inside AirVisual Pro.
During normal operation, you will
not be exposed to laser radiation.
When operated according to the
manufacturer’s instruction, this
device is a Class 1 laser product
as dened by U.S. Department
of Health and Human Services
standards under the Radiation
Control for Health and Safety Act
of 1968.
Important safety information

8
Important safety information
WARNING The use of controls,
adjustments, or procedures
other than those specied in this
manual may result in exposure to
hazardous optical radiation.
FCC Statement
Any changes or modications not
expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the equipment.
Note: This equipment has been
tested and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC
Rules. These limits are designed
to provide reasonable protection
against harmful interference in
a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance

9
Important safety information
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna;
• Increase the separation between
the equipment and receiver;
• Connect the equipment to an outlet
of a circuit different from that to
which the receiver is connected;
• Consult the dealer or an
experienced radio/TV technician
for help.

10
ISED RSS notice - Avis d’ISDE
RSS
This device complies with ISED
licence exempt RSS standard(s).
Operation is subject to the following
two conditions: (1) this device may
not cause interference and (2) this
device must accept any interference,
including interference that may
cause undesired operation of the
device.
Cet appareil est conforme aux
normes RSS exemptes de licence
d’ISDE. Son fonctionnement
est soumis aux deux conditions
suivantes: (1) cet appareil ne doit
pas provoquer d’interférences
et (2) cet appareil doit accepter
toute interférence, y compris les
interférences susceptibles d’entraîner
un fonctionnement indésirable de
l’appareil.
ISED Radiation Exposure Statement
- Déclaration d’ISDE sur l’exposition
aux radiations
This equipment complies with ISED
RF radiation exposure limits set forth
for an uncontrolled environment. This
transmitter must not be co-located
or operating in conjunction with any
other antenna or transmitter.
Cet équipement est conforme
Important safety information

11
aux limites d’exposition aux
rayonnements RF d’ISEDC établies
pour un environnement non
contrôlé. Cet émetteur ne doit pas
être colocalisé ou fonctionner en
conjonction avec une autre antenne
ou émetteur.
Any changes or modications not
expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the equipment.
Tout changement ou modication
non expressément approuvé par la
partie responsable de la conformité
pourrait annuler le droit de l’utilisateur
à faire fonctionner l’équipement.
Important safety information

12
Getting started
iqair.com/air-quality-app
Power on the AirVisual Pro
Connect the supplied USB power cable
to the supplied USB power adapter and
to the back of the AirVisual Pro. Connect
the power adapter to a suitable electrical
wall outlet. The AirVisual Pro will now
take a few seconds to power up.
Connect your AirVisual Pro with the
App
Go to “Devices” and select “ADD DEVICE”
on the top of the phone screen. Scan
the device QR code on the AirVisual Pro
screen or enter the serial number.
Download the AirVisual App
Scan this QR to get to the appropriate
App store.

13
AirVisual Pro controls
Power Button
• Switch the AirVisual Pro on/
off with a 3-second press.
• Enter/exit the device’s sleep
mode with a quick press.
• Go back in the menu
settings with a quick press.
Menu Button
• Access your AirVisual Pro’s
menu and settings.
• Make selections in the menu
for: setting your clock, units,
change languages, brightness
and power saving mode.
Navigation Button
• Navigate through your
AirVisual Pro’s settings.
• Navigate between slideshow
screens.
Power /
Sleeping Mode /
Back
Menu /
OK
Up / Down
Left / Right

14
Home screen
If no outdoor location is selected, the screen shows only indoor air quality
information. Please note the CO2 sensor can take up to two days to calibrate to
display accurate readings.
AQI icon
Indoor AQI
AQI history
(last 24H)
CO2gauge
CO2value
(ppm)
CO2history
(last 24H)
Device name
Status bar
Humidity Indoor AQI Time CO2Temperature

15
Home screen
When connected to Wi-Fi and an outdoor location is selected, the home screen will
display indoor air quality on the left and outdoor air quality on the right side of the
screen.
Device name
AQI icon
Indoor AQI
A Q I h i s t o r y
(last 24H)
Outdoor AQI
Selected
outdoor
station
Outdoor AQI
history
(last 24H)
Status bar
CO2Outdoor AQI Outdoor temperature
& weather
TimeIndoor AQI

16
Indoor screen
This screen provides indoor air quality data including CO2 concentration,
temperature and humidity. The screen only appears when an outdoor location has
been selected. Please note the CO2 sensor can take up to two days to calibrate to
display accurate readings.
CO2 gauge value
(ppm)
Temperature
(°F/°C)
CO2 history
(last 24H)
Device name
Relative
humidity
(%)

17
Forecast screen
The forecast screen shows an air pollution and weather forecast for the next two
days. This requires that an outdoor comparison (your own outdoor monitor, a public
air quality station, or a city) has been selected for AirVisual Pro.
Selected
outdoor
location
Timeline
Outdoor AQI
forecast
W e a t h e r
forecast

18
Recommendations screen
The recommendations screen prominently displays time and date and practical
insights and tips to improve air quality. The advice and status icons are described
on the next page.
Advice icons
Advice text
Wi-Fi status
Battery status
Time & date

19
Advice and status icons
Open your windows to bring
in fresh, clean air
Enjoy your outdoor activities
Run an air purier to lower
indoor pollution
Connected to Wi-Fi and the
internet
Connected to Wi-Fi but not to
the internet
Close your windows
Avoid outdoor activities
Wear a mask outside
Not connected to Wi-Fi
100% Remaining battery life

20
Air Quality Index (AQI) icons*
Good
0 - 50
Little to no health risk
Moderate
51 - 100
Sensitive individuals may
experience irritations
Unhealthy for
Sensitive Groups**
101 - 150
Sensitive groups should limit
outdoor exertion
Unhealthy
151 - 200
Harmful for sensitive groups,
reduced outdoor activity
Very Unhealthy
201 - 300
Everyone can be affected.
Avoid heavy outdoor activity
Hazardous
301 +
Serious risk of respiratory
effects. Everyone should avoid
outdoor activities
* Following US EPA Standards for Particle Pollution to calculate AQI
**Sensitive groups include people with respiratory or heart disease, children and the elderly