Isenberg ECOMATIC 250.1000 User manual

InstallationManualFor250.1000-SingleHoleFaucet
MadeForResponsibleLuxury
NOTICETOHOMEOWNER
• We recommendthatthisproductisinstalledbyaqualified 
professionalplumber.
•Pleasecheckthisproductimmediatelytoensurethatithas
notbeendamagedandiscomplete.Beforeinstallation,please
makesurethisproductisthecorrectmodelandyouhaveall
thepartsrequiredforinstallationanduse.
•Pleaseflushthewatersystemtoensurethatnometalswarf,
solder,andotherimpuritiescanentertheproduct.
•
Turnoffwatersupplybeforecommencingwork. 
•Pleasereadtheseinstructionscarefullyandretainforfuture
reference.
BEFOREYOUBEGIN

•Youmustobservealllocalplumbinglawsandcodes.

•Donotinstallthisproductifitdoesnotmeetplumbingcodes.
•Shutoffthemainwatersupply.

www.isenbergfaucets.com
Ver. 2.53

MadeForResponsibleLuxury
INSTALLINGTHESINGLEHOLEFAUCET
www.isenbergfaucets.com
Step 1
Shut o water supply. Remove old faucet.
Clean the surface in preparation for new
faucet.
1
2
Step 2
Place new faucet through hole on top of sink.
Install the rubber washer (1), and metal washer (2)
onto the threaded mounting shank. Thread the nut (3)
onto the mounting shank. Lock the nut (3) into
position by tightening the screws (4). Do not overtighten.
Step 3
Thread the nut (1) on supply line onto outlet
of water supply valve (2) and tighten with
wrench. Do not overtighten.
1
3
2
4
Step 4
Important: After installation is completed, remove aerator
with plastic wrench. Turn on water supply and allow both
hot and cold water to run for at least one minute
each. While water is running, check for leaks.
Replace aerator. This ushes away any debris
that could cause damage to internal parts.