iSimple ISFM22 User manual
ISFM22
TranzItTM BLU
WIRELESS BLUETOOTH AUDIO
TO ANY CAR RADIO
MAKE THE CONNECTION
iPod or iPhone
Rev.111011
iSimple®
A Division of AAMP of America™
13190 56th Court Clearwater, FL 33760
Ph. 866-788-4237
©2011 AAMP of Florida, Inc.
www.isimplesolutions.com
Table of Contents
Pages
1. Introduction 2
2. ISFM22 Components 2
3. Installation Options 2
4. Frequency Selection and
App Operation 3
5. Bluetooth pairing and connecting 3
6. Troubleshooting
3
7. Warranty Information
4
2
1. Introduction
Thank you for choosing the iSimple ISFM22 as your audio input solution. The ISFM22 (TranzIt
BLU) is designed to provide the connecting link between your iPod or iPhone, and your vehicle.
This interface provides a Bluetooth connection point for your iPod or iPhone, and delivers
streaming audio directly into your radio.
2. ISFM22 Components
• Radio input module
• Application (Free download from the app store)
3. Installation Options (Choose A or B)
The ISFM22 interrupts the incoming antenna signal when in use, to deliver the cleanest
audio possible from your device. To regain standard FM operation without interruption,
simply pause the iPod or iPhone, and approximately 8 seconds later the full FM band will be
accessible. There is also a power on/off/auto option in the TranzIt BLU app. If manual power
on/off control of the ISFM22 is desired, disconnect the “loop plug”, and plug the “optional
toggle switch” into the power harness, in its place. This will allow the user to turn the ISFM22
on or off at any time.
A. Connecting to any FM equipped radio
1) Red Wire. Connect to switched accessory power (not constant)
2) Black Wire. Connect to ground.
3) Antenna input. Connect antenna lead from the vehicle.
4) Antenna output. Connect antenna lead into back of radio.
Note: Antenna adaptors may be needed for select vehicles!
TheISFM22iscompatiblewithampliedantennasystems,andadaptors.
B. Connecting to a radio equipped with an RCA auxiliary audio input
1) Red Wire. Connect to switched accessory power (not constant)
2) Black Wire. Connect to ground.
3) RCA connections. Use these connectors when the radio is equipped with an
RCA audio input. Connect a short pair of stereo RCA cables to this output, and
into the radio’s aux input.
The antenna connectors are not used in this conguration.
Connecting to a radio equipped with an RCA auxiliary audio input
to auxiliary audio
input on back of radio
iPod or iPhone
(not included)
switched accessory
ground
Connecting to any FM equipped radio
Antenna In*
Antenna Out*
ISFM22
app | 106.3 | 88.3 | 87.9
Side of
ISFM22
controlled
Loop plug
Optional toggle switch
switched accessory
ground
Antenna In*
Antenna Out*
ISFM22
Loop plug
Optional toggle switch
iPod or iPhone
(not included)
Connecting to a radio equipped with an RCA auxiliary audio input
to auxiliary audio
input on back of radio
iPod or iPhone
(not included)
switched accessory
ground
Connecting to any FM equipped radio
Antenna In*
Antenna Out*
ISFM22
app | 106.3 | 88.3 | 87.9
Side of
ISFM22
controlled
Loop plug
Optional toggle switch
switched accessory
ground
Antenna In*
Antenna Out*
ISFM22
Loop plug
Optional toggle switch
iPod or iPhone
(not included)
3
4. Frequency Selection and
App Operation
Selecting the ISFM22 Frequency
The factory-set operating frequency is 88.3 FM. If an alternate frequency is desired, the
frequency may be easily adjusted using the selector switch on the side of the module (see
illustration). For full frequency tuning control, visit the app store to download the free app for
TranzIt BLU.
5. Bluetooth Pairing and Connecting
To pair your iPod or iPhone with the ISFM22 (this is only required the rst time you use the
TranzIt BLU, after being paired, it will automatically reconnect with your iPod or iPhone
when returning to the vehicle)
A. Turn the vehicle on.
B. Open your device’s Bluetooth settings menu, and search for new
Bluetooth adaptors.
C. Select the device called “TranzItBLU”. Choose “Connect”
Note: If pairing is not successful within the rst 2 minutes after turning the vehicle on, cycle
ignition off, then begin again at step A
Connecting to a radio equipped with an RCA auxiliary audio input
to auxiliary audio
input on back of radio
iPod or iPhone
(not included)
switched accessory
ground
Connecting to any FM equipped radio
Antenna In*
Antenna Out*
ISFM22
app | 106.3 | 88.3 | 87.9
Side of
ISFM22
controlled
Loop plug
Optional toggle switch
switched accessory
ground
Antenna In*
Antenna Out*
ISFM22
Loop plug
Optional toggle switch
iPod or iPhone
(not included)
6. Troubleshooting
Symptom Cause Remedy
No Audio from the iPod or
iPhone 1) The radio is not set to the
correct station Tune to the default frequency: 88.3FM
2) Device is not paired Please reference section 5
for device pairing.
Cannot access regular
FM stations ISFM22 is active. Pause the iPod or iPhone, and wait 8
seconds.
Access the ISFM22 App, and select the
OFF option.
Audio is distorted The input from the android
source is too loud. turn down the volume on the iPod or
iPhone until distortion is no longer
heard.
Can not nd TranzIt BLU
when searching bluetooth
devices
The TranzIt BLU is no longer in
pairing mode (lasts 2 minutes
after key on)
Turn the vehicle off, then back on again,
try to pair within the rst 2 minutes of
key on.
Message appears on
iPod or iPhone device If
a message appears on
your device sating “Pairing
unsuccessful” Make sure
“TranzIt BLU” is turned
on, in range, and is ready
to pair.
The device did not properly
establish a bluetooth connection Press "Connect" again. If pairing
continues to fail, cycle ignition off, back
on and try pairing again.
4
7. Warranty Information
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction.
This warranty applies only to the original purchaser of this product from an authorized
iSimple®dealer. This warranty covers any supplied or manufactured parts of this product that,
upon inspection by iSimple®authorized personnel, is found to have failed in normal use due
to defects in material or workmanship. This warranty does not apply to installation expenses.
Attempting to service or modify this unit, operating this unit under conditions other than the
recommended voltage will render this
WARRANTY VOID.
Unless otherwise prescribed by law, iSimple®shall not be liable for any personal injury, prop-
erty damage and or any incidental or consequential damages of any kind (including water
damage) resulting from malfunctions, defects, misuse, improper installation or alteration of
this product. All parts of this iSimple®product are guaranteed for a period of 1 year as follows:
Within the rst 12 months from date of purchase, subject to the conditions above, iSimple®
will repair or replace the product at our discretion, if it is defective in material or workmanship
providing it is returned to an Authorized iSimple®’ dealer, with PROOF OF PURCHASE from
an authorized iSimple®dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation.
Exposure to direct sunlight or extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment gener-
ates, uses, and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that of which the receiver
is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modications not expressly approved by the party responsible com-
pliance could void the user authority to operate the equipment.
For best performance, have it
professionally installed.
www.iSimpleSolutions.com
A division of AAMP of America™
13190 56th Court Clearwater, Florida 33760
Ph. 866-788-4237
©2011 AAMP of Florida, Inc.
Table of contents
Other iSimple Radio manuals
