Itel A32F User manual

USER MANUAL
MOBILE PHONE
MODEL:A32F
HEREBY, ITEL MOBILE LIMITED
DECLARES THAT THIS MOBILE PHONE IS IN
COMPLIANCE WITH THE ESSENTIAL
REQUIREMENTS AND OTHER RELEVANT
PROVISIONS OF DIRECTIVE 2014/53/EU.

1 TAKING CARE OF YOUR DEVICE
2 KNOW YOUR PHONE
3 SIM/SD CARD INSTALLATION
4 MAKE CALLS
5 MESSAGES
6 CAMERA
7 WIFI
8 MUSIC
9 FINGERPRINT
10 WARRANTY CONDITIONS
11 SAR
12 EWASTE、RECYCLE YOUR PHONE
13 DISCLAIMERS
14 COPYRIGHTS
15 CAUTION
16 DECLARATION OF CONFORMITY
2
6
7
8
9
10
11
12
13
14
17
19
22
23
24
26
1

2
1 TAKING CARE OF YOUR DEVICE
Your device is a product of superior design and
artisanship and should be handled with care: The
following suggestions will help you protect your
phone :
Keep the device dry. Precipitation, humidity,
and all types of liquid or moisture can contain
minerals that will rust electronic circuits.If your
device gets wet and your device battery is
removable, please remove the battery and
refrain from turning on the device, wipe it with
dry cloth and take it to the service center. If
your device gets wet and your device battery
is un-removable, please don’t reboot your
device and take it to the service center.
Do not store the device in higher than 60°C or
lower than -20°C temperature. Otherwise it
can shorten the life of electronic devices and
damage batteries.
Fully understand user manual before use

3
Do not drop, knock, or shake the device.
Rough handling can break internal circuit
boards and ne mechanics.
Do not use harsh chemicals, cleaning solvents,
or strong detergents to clean the device. Use a
soft, clean and dry cloth to clean the surface of
the device.
Battery& Chargers Safety:
Do not use or store the device in dusty or dirty
areas. Its moving parts and electronic
components may be damaged.
Do not attempt to open the device other than as
instructed in this guide. Repairing of phone by
yourself and others than our authorized service
agent/center is against the warranty rules.
Only use original battery, charger and
accessories applicable to the specic mobile
model. Using other types of battery, charger
If your device support hot plug SD card or SIM
card, you can plug the SD card during the
device running, otherwise you need to plug
the SD card or SIM card after power o the
device or remove the battery.

4
Do not place the battery or devices in re or
heating devices, such as microwave ovens,
stoves, or radiators and improper disposal of
batteries may lead to explosion.stoves, or
radiators and improper disposal of batteries
may lead to explosion.
Return waste and used batteries to the
supplier or specied recovery site.
Stop charging when battery is higher than 55℃,
and restore charging when below 50℃.
If the time span of the battery after charging
becomes much shorter than usual, the battery
life is at an end. Replace the battery with a new
battery of the same make and specication.
*Notes:
and accessories may violate the certication or
warranty terms of the equipment and may
result in danger.

If you want to know more:
www.itel-mobile.com
www.facebook.com/itelmobile
Twitter.com/itel_mobile
If your device battery is removable, you can
keep pressing the power button for 10 seconds
to restart the phone. If your device battery is
un-removable,you can reset the battery to
restart the phone.
5

2 KNOW YOUR PHONE
1. Earphone plug
3. Light proximity sensor
5. Receiver
7. USB port
9. Flash
11. Power button
2. Front ash
4. Microphone
6. Front camera
8. Rear camera
10. Volume button
12. Speaker
6
1. Earphone plug
3. Receiver
5. USB port
7. Volume button
9. Flash
11. Fingerprint
2. Front camera
4. Front ash
6. Microphone
8. Power button
10. Rear camera

3 SIM/SD CARD INSTALLATION
1. Power o mobile.
2. Refer to the following picture for SIM / SD card
installation.
7

4 MAKE CALLS
On dial interface and enter a complete phone
number to make a call.
Call Recorder Storage Path:
No SD Card: internal shared storage / recorder /
Call Recorder
SD Card inserted and SD Card is default write disk:
SD card / recorder / Call Recorder
8
100%
100%

5 MESSAGES
You can use Messages to exchange text and
multimedia messages with your friends.
9
100%

6 CAMERA
You can select the camera APP to take photos. You
can switch the rear camera and front camera to
take photo on camera APP, you can select Beauty
or PANO or Lowlight mode to take photo in
dierent environment. You can generate photos
into dierent eect by using a Filter or Vignette or
Watermark.
10

7 WI-FI
To browse the web, you need switch on Data
connection.If there is Wi-Fi around, you can switch
on Wi-Fi to use it browse the web. Some may need
password.
11

8 MUSIC
When you copy music to your SD card, the Music
player searches the card for music les and builds
a catalog of your music, based on information
about each le that is stored in the le itself.
12

9 FINGERPRINT
Use a ngerprint to unlock the screen or to
encrypt your important data and privacy
information.
Add ngerprint or delete Fingerprints
You can enter Settings application, click
Security and select ngerprint to add
ngerprints.
You can also click on the Fingerprint
application icon directly to add ngerprints.
Note:
1.You need to choose your backup screen lock
method before adding Fingerprint.
2.You can click the ngerprint in Fingerprint
list and then choose to delete it.
You can use ngerprint to answer a call or to
take a photo or to start call recorder.
13

10 WARRANTY CONDITIONS
The warranty period starts at the time of product's
original purchase by the rst end-user. The
product may consist of several dierent parts and
dierent parts may be covered by a dierent
warranty.
This Limited Warranty does not cover user
manuals or any third party software, settings,
content, data or links included or downloaded
in the product, whether included during
installment, assembly, shipping or any other
time in the delivery chain or otherwise and in
any way acquired by you. Itel does not warrant
that any Itel software will meet your
requirements, will work in combination with
any hardware or software provided by a third
party, that the operation of any software will be
uninterrupted or error free or that any defects in
the software are correctable or will be
corrected.
What is not covered?
1.
14
This Limited Warranty does not cover2.

(a) Normal wear and tear (including, without
limitation, wear and tear of camera lenses,
batteries, or displays)
(b) Defects caused by rough handing (including,
without limitation, defects caused by sharp
objects, by bending, compressing or
dropping,etc.)
(c) Defects or damage caused by misuse of the
Product, including use that is contrary to the
instructions provided by itel (e.g. as set out
in the Product's user guide).
(d) Transport costs.
(e) Other acts beyond the reasonable control of
itel.
The Limited Warranty does not cover defects or
alleged defects caused by the fact that the
product was used with, or connected to, any
product, accessory, software and/or service not
manufactured, or supplied, by itel or was used
otherwise than for its intended use. Defects can
be caused by viruses from your or a third party's
unauthorized access to services, other
accounts,computer systems or networks. This
unauthorized access can take place through
hacking, password mining or through a variety
of other means.
3.
15

This Limited Warranty does not cover defects
caused by the fact that the battery has been
short-circuited or by the fact that the seals of
the battery enclosure or the cells are broken or
show evidence of tampering or by the fact that
the battery has been used in equipment other
than those for which it has been specied.
4.
This Limited Warranty is not enforceable if the
Product is opened, modied or repaired by
anyone other than an authorized service centre,
if it is repaired using unauthorized spare parts
or if the Product's serial number, the mobile
accessory date code or the IMEI number has
been removed, erased, defaced, altered or are
illegible in any way and this shall be determined
in the sole discretion of itel.
16
5.
This Limited Warranty is not enforceable if the
Product has been exposed to moisture, to
dampness or to extreme thermal or environ-
mental conditions or to rapid changes in such
conditions, to corrosion, to oxidation, to spillage
of food or liquid or to inuence from chemical
products.
6.

11 SAR
17
Specic Absorption Rate (SAR) Certication
THIS DEVICE MEETS INTERNATIONAL GUIDELINES
FOR EXPOSURE TO RADIO WAVES
Your mobile device is a radio transmitter and
receiver. It is designed not to exceed the limits for
exposure to radio waves (radio frequency
electromagnetic elds) recommended by
international guidelines. The guidelines were
developed by an independent scientic
organization (ICNIRP) and include a substantial
safety margin designed to assure the safety of all
persons, regardless of age and health.
The radio wave exposure guidelines use a unit of
measurement known as the Specic Absorption
Rate, or SAR. The SAR limit for mobile devices is 2.0
W/kg. Tests for SAR are conducted using standard
operating positions with the device transmitting
at its highest certied power level in all tested
frequency bands. The highest SAR values under
the ICNIRP guidelines for this device model are:
Maximum SAR for this model and conditions
under which it was recorded

Head
Body
1.171 W/Kg
1.200 W/Kg
During use, the actual SAR values for this device
are usually well below the values stated above.
This is because, for purposes of system eciency
and to minimize interference on the network, the
operating power of your mobile device is
automatically decreased when full power is not
needed for the call. The lower the power output of
the device, the lower its SAR value.
A body-worn SAR test has been performed on this
device at a separation distance of 5 mm. To meet
RF exposure guidelines during body-worn
operation, the device must be positioned at least
5 mm away from the body.
Organizations such as the World Health
Organization and the US Food and Drug
Administration have suggested that if people are
concerned and want to reduce their exposure,
they could use a hands-free accessory to keep the
wireless device away from the head and body
during use, or reduce the amount of time spent
using the device.
18

12 E-WASTE、RECYCLE
YOUR PHONE
The WEEE logo (shown at the left)
appears on the product (battery,
handset, and charger) to indicate
that this product must not be
disposed o or dumped with your
other household wastes. You are
liable to dispose of all your electronic or electrical
waste equipment by relocating over to the
specied collection point for recycling of such
hazardous waste.
Collection and proper recovery of your electronic
waste equipment’s at the time of disposal will
allow us to help preserve the environment.
Recycling of the electronic waste equipment will
ensure safety of human health and environment.
INFORMATION UNDER E-WASTE (MANAGEMENT
AND HANDLING) RULES, 2011
For disposal of e-waste, please call our helpline no.
or visit our website.
E-waste Helpline no.:18004190525
Website: www.itel-mobile .com
19
Table of contents
Other Itel Cell Phone manuals