USB Rechargeable
Manual & Electric Screwdriver
EKdriver
This product supports manual and electric operation, and is primarily intended to be used with the special
tool for twist on EK F connectors mounting, “EKey”. Likewise is applicable to tightening and unscrewing
screws, DIY furniture assembly and other daily household or professional use. Please read the user manual
carefully and use it properly. Thank you for your purchase.
REFERENCE EKdriver
Code 167006
Battery capacity 18650 lithium battery 3,6V 2000mAh
No load speed 280 RPM
Hex chuck diameter 6,35mm
Maximum torque 6N.m (electric); 20N. (manual)
Charging time 60 mins
Continuous using time 200 mins (input 5V, 1A)
Charging port Micro 5pin-USB charging cable (included)
Charging voltage W5 & 1A
Weight 150g (only the main body)
Working ambient temperature -10ºC - 40ºC
Charging ambient temperature 4ºC - 40ºC
Accessory May very depending on product sets
MICRO 5in USB charging
Red light Charging
Green light Fully charged
ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
The EKdriver rechargeable battery is replaceable. Unscrew the two small Phillips screws on the end of the
screwdriver, Install the battery with the positive terminal facing inward.Then tighten the screws back to finish
the battery replacement.
1. Please charge with the Micro 5pin USB charging cable provided.
2. Please insert the USB charging cable into USB outlet port (such as laptop, AC adapter, power bank, etc.).
3. After complete charging, please unplug the USB charging cable from the USB outlet port first, then re-
move it
from this product.
4. The charging time is about 60 minutes.
5. Please do not use this product during charging, which may damage the battery or shorten its life.
Charging/Battery
Product description
Charging indicator light
Charging port with dust cap
EKey (optional, may not be included)
LED work light
Forward button
Non-slip rubber gruip
Bettery holder
(lithium battery is included)
Reverse button
